Porsche Cayenne I 1 owners manual page 243

text version of content this owner's manual page from owners manual to the vehicle Porsche Cayenne, year of production 2002 - 2010:

10_Cayenne_21_KW17.book Seite 243 Donnerstag, 9. April 2009 3:33 15 2. Hold the original remote control approx. 2. Press the previously programmed button on 5–30 cm in front of the marked position C. the keypad three times (for approx. 1 second). Make sure that the battery in the original Changeable-code synchronization is now com- remote control is new. pleted. 3. Press and hold the button on the original remo-3. Repeat steps 1 to 2 to synchronize other te control until light-emitting diode B flashes ra-signals to the other buttons. pidly. The rapidly flashing LED B confirms that the re-Note mote control function has been programmed f Please consult an authorized Porsche dealer if successfully. you have not been able to successfully assign Only release both buttons when LED B flashes. signals to the buttons even though you have 4. Press the programmed button on keypad A.carefully followed the instructions in this If the light-emitting diode B lights up conti-section and the operating instructions for the nuously after programming, this means that original remote control. Your authorized the system is a fixed-code system. Program-Porsche dealer also has a list of all compatible ming is now completed. garage door opener systems. If light-emitting diode B again flashes rapidly Programming a button on the keypadfor a short time after programming and then Operating the garage door opener lights up continuously for approx. 2 seconds, f Press the corresponding button on keypad A. Caution! this means that the system is a changeable- Risk of damage. When programming a gara-code system. HomeLink must then be synchro-Light-emitting diode B lights up continuously ge door or gate, the door or gate may open nized with the receiver of the garage door ope-during signal transmission with fixed-code and close several times in quick succession, ner after programming.systems. causing the motor to overheat.5. Repeat steps 1 to 4 to program the other In the case of signal transmission for change- buttons. able-code systems, light-emitting diode B f Unplug the garage door or gate during the pro- repeatedly lights up rapidly for a short time gramming procedure to prevent the motor Synchronization for changeable-code and then lights up continuously for approx. from overheating. systems 2seconds. 1. Press and hold the desired button on the 1. To synchronize the system: keypad until light-emitting diode B starts to Press the programming button on the receiver flash slowly (may take up to 20 seconds). of the garage door opener. Do not release the button before step 3 has Afterwards, you usually have approx. been completed. 30seconds to initiate step 2. Parking 243

owners manual Porsche Cayenne

owners manual Porsche Cayenne - year of production: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010 - Porsche Cayenne I 1 owners manual EN