owners manual Seat Exeo

all ratings: 0 average rating: 5

exeo_EN.book Seite 240 Montag, 30. August 2010 4:45 16 240 Wheels and tyres Significant tyre pressure loss wheels. If the rolling circumference or frequency characteristic changes on one or more wheels, the tyre pressure warning lamp ~ will light up. The fault The tyre symbol ~ is displayed and indicates that the tyre pressure of at least will also be indicated by a warning buzzer. The position of the affected tyre one tyre is insufficient. will also be shown (if only one tyre is affected) on the centre display of the instrument panel. - Stop the vehicle. The rolling circumference and frequency characteristics can change if: - Switch the engine off. • the tyre pressure is too low. - Check the tyre(s). • the tyre has suffered structural damage. - Change the tyre if necessary. • the wheels or the inflation pressures have been changed without initial- ising the system (see Adjusting the tyre pressure settings). • there is a greater load on the wheels of one axle (e.g. if you are carrying Tyre pressure monitoring (RKA+)* more passengers or luggage). • the road surface under the left wheels is different to the road surface The tyre pressure monitor display on the instrument panel under the right wheels for a long period. indicates if the pressure is too low. • when driving with snow chains. Adjusting the tyre pressure settings (initialising the tyre pressure monitoring system) After any incident regarding the wheels of your vehicle, e.g. after modify the tyre pressure ⇒ page 241 or after changing or swapping around wheels ⇒ page 180 - with the vehicle at a standstill and the engine running - press ⇒fig.173. The yellow warning lamp ~ will light up. Hold the button down for 2 seconds until the warning lamp goes out and an acoustic warning is given. You can now release the button. If the wheels are subjected to extreme stress (e.g. heavy load), the tyre pres- sure must be increased to the recommended value for the maximum load Fig. 173 Detailed view of (see the adhesive label on the inside of the fuel tank flap) and then initialise the centre console: Button the system. for the tyre pressure monitoring systemTyre pressure warning lamp on When you switch on the ignition, the tyre pressure warning lamp ~ will light The tyre pressure monitoring system makes use of the ABS sensors to up for about 2 seconds. There is a fault in the system if the indicator stays on compare the rolling circumference and the frequency characteristics of the permanently after switching on the ignition. The instrument panel also

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders