owners manual Nissan Rogue

all ratings: 0 average rating: 5

Black plate (248,1) . Waste oil must be disposed of 10.Clean and re-install the drain plug with aAfter the operation properly. newwasher. Securely tighten the drain plug1.Lower the vehicle carefully to the ground. . Check your local regulations.with a wrench. Drain plug tightening torque:2.Dispose of waste oil and filter properly. Perform steps 4 to 9 when the engine oil22 to 29 ft-lb filter change is needed. (29 to 39 N·m) WARNING 4.Remove the plastic cover over the oil filterDo not use excessive forceProlonged and repeated contact location by removing the small plastic clips.11. Refill engine with recommended oil throughwith used engine oil may cause skin 5.Loosen the oil filter with an oil filter wrench.the oil filler opening, and install the oil fillercancer. Remove the oil filter by turning it by hand.cap securelyTry to avoid direct skin contact with 6.Wipe the engine oil filter mounting surfaceSee “CAPACITIES AND RECOMMENDEDused oil. If skin contact is made, with a clean rag. FUEL/LUBRICANTS” in the “9. Technicalwash thoroughly with soap or hand and consumer information” section for draincleaner as soon as possible. CAUTION and refill capacity. The drain and refill.Keepusedengineoiloutofreachof capacity depends on the oil temperaturechildren. Be sure to remove any old gasketand drain time. Use these specifications for material remaining on the mountingreference only. Always use the dipstick to surface of the engine. Failure to do sodetermine the proper amount of oil in the could lead to engine damage.engine. 12. Start the engine and check for leakage 7.Coat the gasket on the new filter with cleanaround the drain plug and the oil filter. engine oil. Correct as required. 8.Screw in the oil filter clockwise until a slight13. Turn the engine off and wait more than 10 resistance is felt, then tighten additionallyminutes. Check the oil level with the dipstick. more than 2/3 turn. Add engine oil if necessary. Oil filter tightening torque: 11 to 15 ft-lb (14.7 to 20.5 N·m) 9.Install the plastic cover. 8-10 Maintenance and do-it-yourself Model "S35-D" EDITED: 2007/ 12/ 19

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders