or
owners manual Skoda Yeti
owners manual Skoda Yeti - year of production: 2009 - Skoda Yeti owners manual EN
Document:
pdf (15.42 MB) 271 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle Skoda Yeti, year of production 2009:
s2ug.6.book Page 240 Friday, April 9, 2010 2:24 PM
240 Fuses and light bulbs
– Remove the rubber protective cap A page238, fig.188.
A Changing light bulbs in the rear light unit
– Unplug plug A 1 .
2
– Take the faulty bulb out of the fixture A by turning in direction of arrow and insert
a new one in the reverse procedure.
– Insert the protective cap.
Rear light unit
Fig. 195 Remove the middle part of the light / rear light unit: Fitting position of the bulbs
– Unscrew the securing screw A A with the aid of the Torx wrench and press the three
catches in direction of arrow fig. 195.
– Remove the plastic lamp holder.
– Replace the defective light bulb.
Fig. 194 Removing the rear light unit / disconnecting the plug connection – In order to replace a bulb for the brake light, reversing light, rear fog or turn signal
light, turn the fixture of the bulb to the left up to the stop and take the bulb out of
– Open the boot lid. the housing or pull the bulb for the parking light out of the fixture fig. 195.
– Unscrew the light with the aid of the Torx wrench from the vehicle tool kit. The – Change the bulb, install again the fixture with the bulb in the housing and turn it to
shorter side of the wrench is used for loosening the screws and the longer side for the right up to the stop or insert it.
screwing the screws out completely 1 fig. 194.
A – Insert the plastic lamp holder into the illumination unit until the interlocks are
– Grasp the light at the top and bottom part and pull it slightly to the rear. heard to engage and screw in the securing screw with the aid of the Torx wrench
fig.195.
– Disconnect the plug connection by pressing the catches in direction of arrow 2
A
and by pulling them in direction of arrow 3 fig. 194. – Reconnect the plug connector and insert the bulb in the original position.
A
– Screw on the bulb fig.194 - left.
Fitting position of the light bulbs in the rear light unit fig. 195
A 1 - Brake lights
A 2 - Reversing light
A 3 - Rear fog light
A 4 - Turn signal lights
Download PDF
Click here to download a pdf file with an instruction manual for Skoda Yeti
year of production from: 2009
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Skoda Yeti owners manual
pages 238 - 244
Skoda Yeti owners manual
page 241 / 271
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF