owners manual Seat Alhambra

all ratings: 0 average rating: 5

Advice good performance, a better seal, improved ●Never use tyres which are larger than SEAT workshop. SEAT recommends taking your car safety and wheel run out. Therefore, worn approved tyres. If the tyres are too big, they in for technical service. rims should always be replaced and must on- may knock or rub against the chassis or other ly be repaired in a specialised workshop. components, resulting in damage. SEAT recommends visiting a technical service Replacement of wheel rims and new ››› . WARNING tyres New tyres do not give maximum grip and will Wheel rims with bolted trims not have reached their maximum braking ca- New tyres pacity to start with, and therefore need run- Wheel rims may be fitted with interchangea- ●When tyres are new, drive with extreme ning in. ble trim parts which are attached to the rim caution for the first 500 km, as all tyres need ● To prevent accidents and major damage, using self-locking bolts. Worn trims should to be run-in. Tyres which have not been run- extreme caution should be taken for the first only be replaced at a specialised workshop. in do not have such good grip ››› or brak- 600 km. SEAT recommends visiting a technical service ing capacity ››› . ››› . ●All four wheels must be fitted with radial WARNING tyres of the same type, size (rolling circumfer- WARNING There should be adequate space between the ence) and the same tread pattern. The use of worn or damaged wheel rims could tyres and the vehicle in accordance with the ●The tread depth of new tyres may vary, ac- make driving more dangerous and result in vehicle design. If this is not the case, the serious accidents and damage.cording to the type and make of tyre and the tyres may rub against parts of the running tread pattern. gear, chassis or brake lines, leading to faults ● Only wheel rims which have been approved in the brake system or to tread detachment, for use with your vehicle should be used. Replacing tyres and the risk of burst tyres. ● Inspect wheel rims regularly for damage ● The true tyre dimension should not be and replace as required.●Where possible, always replace both greater than the dimensions of tyres manu- wheels on an axle (both wheels on the front factured and approved by SEAT and should axle or both wheels on the rear axle) ››› . WARNING not rub against parts of the vehicle. ●Old tyres should only be replaced by SEAT If the bolted joints of wheel rims with bolted approved tyres for the vehicle in question, ring trims are not correctly tightened or loos- Note and in accordance with the maximum permit- ened, this could result in serious accident. ted size, diameter, load and speed capacity.● Although tyres may be shown as being the ● Never loosen the bolted joints of wheel same size, the true dimensions of different ●If replacing tyres, make sure the new ones rims with bolted ring trims. types of tyre may vary with respect to the have an emergency ride system (Conti- ● Any work relating to wheel rims with bolted nominal size, or tread patterns may be differ- Seal/Run flat). Otherwise, we recommend rims should be carried out at specialised ent. carrying a tyre mobility system. 234

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders