owners manual Suzuki Grand Vitara

all ratings: 1 average rating: 5

OTHER CONTROLS AND EQUIPMENT ® Gate Operator / Canadian Program- Using HomeLink Reprogramming a Single To operate, simply press and release the ® ming ® HomeLink Button ® programmed HomeLink button. Activation Canadian radio-frequency laws require To program a device to HomeLink using a will now occur for the trained device (i.e.® transmitter signals to “time-out” (or quit) HomeLink button previously trained, fol- after several seconds of transmission – garage door opener, gate operator, secu- low these steps: rity system, entry door lock, home/office which may not be long enough for ® ® 1) Press and hold the desired HomeLink HomeLink lighting, etc.). For convenience, the hand- to pick up the signal during button. DO NOT release the button. programming. Similar to this Canadian law,held transmitter of the device may also be 2) The indicator light will begin to flash some U.S. gate operators are designed toused at any time. In the event that there after 20 seconds. Without releasing the “time-out” in the same manner. are still programming difficulties or ques- ® ® HomeLink button, proceed with “Pro- tions, contact HomeLink If you live in Canada or you are having diffi- at ® www.homelink.com or 1-800-355-3515. gramming HomeLink ” – step 2). culties programming a gate operator by using the Programming procedures For questions or comments, contact ® Erasing HomeLink Buttons ® (regardless of where you live), replace HomeLink at www.homelink.com or 1- ® To erase programming from the three but- “Programming HomeLink ” step 3) with 800-355-3515. the following: tons (individual buttons cannot be erased but can be “reprogrammed” as outlined NOTE: below), follow the step noted: ® If programming a garage door opener orPress and hold the two outer HomeLink gate operator, it is advised to unplug thebuttons until the indicator light begins to device during the “cycling” process to pre- flash-after 20 seconds. Release both but- vent possible overheating. tons. Do not hold for longer that 30 sec- ® onds. HomeLink is now in the train (or 3) Continue to press and hold the ® learning) mode and can be programmed at HomeLink button while you press and any time beginning with “Programming release – every two seconds (“cycle”)HomeLink®” – step 2). your hand-held transmitter until the fre- quency signal has successfully been accepted by HomeLink®. (The indicator light will flash slowly and then rapidly.) ® Proceed with “Programming HomeL” ink step 4) to complete. 5-82 79K21-03E

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders