owners manual Skoda Octavia

all ratings: 0 average rating: 5

20A5Facelift.book Page 230 Saturday, September 6, 2008 2:13 PM 230 Inspecting and replenishing Losses can only occur through the pressure relief in the cap of the coolant expan-Do not fill up over the “MAX” marking! Excess coolant which is heated up is forced sion bottle which is completely free of leaks if the coolant boils as a result of over-out of the cooling system through the pressure relief valve in the cap of the coolant heating and is forced out of the cooling system.compensation bottle. Wait until the engine has cooled down for a system which has suffered a major loss WARNING of coolant before pouring in coolant. This is necessary to avoid engine damage. Read and observe the warning notes ⇒page225, “Working in the engine compartment” before working in the engine compartment.WARNING • The cooling system is pressurized! Do not open the cap of the coolant Caution expansion bottle if the engine is still hot - risk of scalding! One should contact a specialist garage as soon as possible if the source of over-• The coolant additive and thus all of the coolant is harmful to your health. heating itself cannot be determined and removed, since there may be grave Avoid contact with the coolant. Coolant vapours are also harmful to the damage to the engine. health. It is important, therefore, to always safely store any coolant additive in its original container out of the reach of children - risk of poisoning! Replenishing the coolant • If any splashes of coolant get into yo ur eyes, rinse out your eyes immedi- ately with clear water and contact a doctor as soon as possible. – Switch the engine off. • You should also consult a doctor without delay if you have inadvertently swallowed coolant. – Allow the engine to cool down. – Place a cloth over the cap of the coolant expansion reservoir Caution ⇒page229, fig.213 and unscrew the cap carefully by turning it to the Do not continue your journey if for some reason it is not possible under the left ⇒ . conditions prevailing to top up with coolant. Switch of the engine and contact and obtain professional assistance from a specialist garage. – Top up the coolant. – Screw the cap tight until it is heard to lock. For the sake of the environment The coolant which you use for replenishing the system, must comply with one Do not re-use coolant if it is necessary to drain the coolant in the system. It should specific specification ⇒ page 228. Do not use an alternative additive if the coolant be collected and disposed of in compliance with environmental protection additive G12 PLUS is not available in exceptional cases. Just top up the system with regulations. water and as soon as possible arrange adjustment to correct the mixing ratio of water and coolant additive again by a specialist garage. Only use fresh coolant for topping up the system.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders