owners manual Seat Leon

all ratings: 0 average rating: 5

228 Intelligent technology To restore the necessary energy balance, the system will then temporarily● Braking force shut off the electrical components that are using a lot of power, or reduce ● Seat belt check the current they are consuming. Heating systems in particular use a large amount of electrical power. If you notice, for instance, that the seat heating*The vehicle control units never record conversations held by passengers in or the heated rear window is not working, they may have been temporarilythe vehicle. switched off or regulated to a lower heat output. These systems will be If the control unit records an accident with airbag activation, the system available again as soon as sufficient electrical power is available. may automatically send a signal. This will depend on the network operator. You may also notice that the engine runs at a slightly faster idling speed.Normally, transmission is only possible in areas with sufficient coverage. This is quite normal, and no cause for concern. The increased idling speed Event Data Recorder allows the alternator to meet the greater power requirement and charge the  battery at the same time. The vehicle is not fitted with an event data recorder. An event data recorder temporarily stores the vehicle information. There- fore, in the event of accident, it is possible to obtain detailed information about how the accident occurred. For example, in vehicles with airbag sys- Information recorded in the control units tems, data relating to speed of impact, seat belt status, seat positions and airbag activation times may be stored. The volume of data depends on the Your vehicle is fitted at the factory with a series of electronic control unitsmanufacturer. responsible for the engine and gearbox management. In addition, the con- Event data recorders can only be mounted with authorisation from the vehi- trol units supervise the correct performance of the exhaust gas system and cle owner and, in some countries, they are governed by local legislation. the airbag systems. Reprogramming control units Therefore, while the vehicle is being driven, these electronic control units are continuously analysing the vehicle data. In the event of faults or devia- On the whole, all the data required for the component management is stor- tions from the theoretical values, only this data is stored. Generally, the in- ed in the control units. The programming of certain convenience functions, strument panel warning lamps indicate whether there are any malfunctions. such as the turn signal convenience mode, individual door opening and dis- play indications can be modified using special equipment at the workshop. This data can only be read and analysed using special equipment. If the convenience functions are reprogrammed, the Instruction Manual in- formation and descriptions will not coincide with the modified functions. The storing of the data allows specialised workshops to detect and repair Therefore, SEAT recommends that any changes are recorded in the “Other faults. Stored data may include: workshop notes section” of the Service Plan. ● Important data about the engine and gearbox You can find out about possible reprogramming at your SEAT Official Serv- ● Speed ice.  ● Direction of travel

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders