owners manual Subaru Forester

all ratings: 0 average rating: 5

3-94 Instruments and controls/Wiper and washer . In freezing weather, be sure thatWasher Fluid or the equivalent.washer solution will be sprinkled all the wiper blades are not frozen toRefer to “Windshield washerover the windshield or rear window. the windshield or rear windowfluid” F11-32. . Grease, wax, insects or other mate- before switching on the wipers.Also, when driving the vehiclerial on the windshield or the wiper Attempting to operate the wiperwhenthere are freezing tempera-blade results in jerky wiper operation with the blades frozen to thetures, use non-freezing type wi-and streaking on the glass. If you window glass could cause notper blades. cannot remove those streaks after only the wiper blades to be operating the washer or if the wiper damaged but also might cause. Do not clean the wiper bladesoperation is jerky, clean the outer sur- the wiper motor to fail. If thewith gasoline or a solvent, suchface of the windshield or rear window wiper blades are frozen to theas paint thinner or benzine. Thisandthewiperbladesusingaspongeor windowglass, be sure to operatewill cause deterioration of thesoft cloth with a neutral detergent or the defroster, windshield wiperwiper blades. mild-abrasive cleaner. After cleaning, deicer (if equipped) or rear win- rinse the window glass and wiper dow defogger before turning onNOTE blades with clean water. The glass is the wiper. . The windshield wiper motor is pro-clean if no beads form on the glass . If the wipers stop during opera-tected against overloads by a circuitwhen you rinse with water. tion becauseoficeorsomeotherbreaker. If the motor operates continu-. If you cannot eliminate the streaking obstruction on the window, thisously under an unusually heavy load,even after following this procedure, might cause the wiper motor tothe circuit breaker may trip to stop thereplace the wiper blades with new fail even if the wiper switch ismotortemporarily. If this happens, parkones. For replacement instructions, turned off. If this occurs, refer to “Replacement of wiper blades” yourvehicle in a safe place, turn off theF11-33. promptly stop the vehicle in awiper switch, and wait for approxi- safe place, turn the ignitionmately 10 minutes. The circuit breaker switch to the “LOCK”/“OFF” po-will reset itself, and the wipers will sition and clean the window again operate normally. glass to allow proper wiper op-. Clean your wiper blades and win- eration. dow glass periodically with a washer . Use clean water if windshieldsolution to prevent streaking, and to washer fluid is unavailable. Inremove accumulations of road salt or areas where water freezes in road film. Operate the windshield winter, use SUBARU Windshieldwasher for at least 1 second so that

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders