owners manual Subaru Forester

all ratings: 0 average rating: 5

Starting and operating7-7 trouble codes, and the OBD systemPreparing to drive Starting the engine readiness monitors are complete. . Avehiclefails the OBD inspection if theYou should perform the following checks “CHECK ENGINE” warning light/MIL isand adjustments every day before youCAUTION not properly operating or there are one orstart driving. more diagnostic trouble codes stored in1. Check that all windows, mirrors, andDo not operate the starter motor the vehicle’s computer with the “CHECKlights are clean and unobstructed.continuously for more than 10 sec- ENGINE” warning light/MIL illuminated.2. Check the appearance and conditiononds. If the engine fails to start after . Astate emission inspection may rejectof the tires. Also check tires for properoperating the starter for 5 to 10 (not pass or fail) a vehicle if the number ofinflation. seconds, wait for 10 seconds or OBD system readiness monitors“Not more before trying again. 3. Look under the vehicle for any sign of Ready” is greater than one. Under thisleaks. condition, the vehicle operator should be4. Check that the hood and rear gate are&Manualtransmission model instructed to drive his/her vehicle for a fewfully closed. days to set the monitors and return for an 1. Apply the parking brake. emission re-inspection. 5. Check the adjustment of the seat.2. Turn off unnecessary lights and ac- . Owners of rejected or failing vehicles6. Check the adjustment of the insidecessories. should contact their SUBARU Dealer forand outside mirrors.3. Press the clutch pedal to the floor and service. 7. Fasten your seatbelt. Check that yourshift the shift lever into neutral. Hold the passengers have fastened their seatbelts.clutch pedal to the floor while starting the 8. Check the operation of the warningengine. and indicator lights when the ignitionThe starter motor will only operate when switch is turned to the “ON” position.the clutch pedal is pressed fully to the 9. Checkthegauges,indicator andwarn-floor. ing lights after starting the engine.4. Turn the ignition switch to the “ON” position and check the operation of the NOTE warning and indicator lights. Refer to Engine oil, engine coolant, brake fluid,“Warning and indicator lights” F3-9. washer fluid and other fluid levels 5. Turntheignitionswitch to the “START” should be checked daily, weekly or atposition without depressing the accelera- fuel stops. tor pedal. Release the key immediately after the engine has started. – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders