owners manual Toyota Land Cruiser

all ratings: 0 average rating: 5

2-3. Operating the lights and wipers ■The windshield wiper and washer can be operated when The “ENGINE START STOP” switch is in IGNITION ON mode. ■Effects of vehicle speed on wiper operation (vehicles with rain-sensing windshield wipers) Vehicle speed affects the wiper operation when the washer is being used (delay until drip prevention wiper sweep occurs) even when the wipers are not in “AUTO” mode. With “ ” selected, wiper operation will be switched from low speed to intermittent wiper operation only when the vehicle is stationary. (However, when the sensor sensitivity is adjusted to the highest level, the mode cannot be switched.) ■Rain drop sensor (vehicles with rain-sensing windshield wipers) ●The sensor judges the amount of rain- drops. ●If the wiper switch is turned to “AUTO” position while the “ENGINE START STOP” switch is in IGNITION ON mode, the wiper will operate once to show that “AUTO” mode is activated. ●If the temperature of the rain drop sensor is F (80176C) or higher, or 14F (-10C) or lower, automatic operation may not occur. In this case, operate the wipers in any mode other than “AUTO”. ■If no windshield washer fluid sprays Check that the washer nozzles are not blocked if there is washer fluid in the windshield washer fluid reservoir. 210 LC200_OM_OM60L83U_(U)

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders