owners manual Mazda MX-5

all ratings: 0 average rating: 5

MX-5_8EN7-EA-14E_Edition1 Page210 Friday, March 28 2014 3:39 PM Black plate (210,1) Driving Your Mazda Switches and Controls 5. Press and hold the just-trained HomeLinkshouldnowactivate your HomeLinkbuttonandobservethe rolling code equipped device. indicator light. NOTE If the indicator light stays on constantly,To program the remaining two HomeLink programmingiscompleteandyour buttons, begin with “Programming”― step 2. device should activate when the Donotrepeat step 1. HomeLinkbuttonispressed and released. For questions or comments, please contact NOTE HomeLinkatwww.homelink.comor1- To program the remaining two HomeLink800-355-3515. buttons, begin with “Programming”― step 2. Donotrepeat step 1. Gate operator/Canadian Programming If the indicator light blinks rapidly forCanadian radio-frequency laws require twosecondsandthenturnstoa transmitter signals to “time-out” (or quit) constant light, continue with after several seconds of transmission ― “Programming”steps 6―8tocomplete which may not be long enough for the programming of a rolling code HomeLinktopickupthesignal during equipped device (most commonly a programming. Similar to this Canadian garage door opener). law, some U.S. gate operators are designed to “time-out” in the same 6. At the garage door opener receivermanner. (motor-head unit) in the garage, locate the “learn” or “smart” button. This canIf you live in Canada or you are having usually be found where the hanging difficulties programming a gate operator antenna wire is attached to the motor-by using the “Programming” procedures head unit. (regardless of where you live), replace 7. Firmly press and release the “learn” or“ProgrammingHomeLink”step3with “smart” button. (The name and color ofthe following: the button may vary by manufacturer.)NOTE NOTE If programming a garage door opener or gate operator, it is advised to unplug the device There are 30 seconds in which to initiate stepduring the “cycling” process to prevent 8. possible overheating. 8. Return to the vehicle and firmly press,Continue to press and hold the HomeLink hold for two seconds and release thebutton while you press and release ― programmed HomeLink button. Repeat every two seconds (“cycle”) your hand- the “press/hold/release” sequence aheld transmitter until the frequency signal second time, and, depending on the has successfully been accepted by brand of the garage door opener (orHomeLink.(Theindicator light will flash other rolling code equipped device),slowly and then rapidly.) Proceed with repeat this sequence a third time to“Programming” step 4 to complete. complete the programming process. 5-66 Form No.8EN7-EA-14E

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders