owners manual Mazda MX-5

all ratings: 0 average rating: 5

MX-5_8EN7-EA-14E_Edition1 Page206 Friday, March 28 2014 3:39 PM Black plate (206,1) Driving Your Mazda Switches and Controls TheHomeLinksystemprovides3buttons NOTE which can be individually selected andTo program the remaining two HomeLink programmed using the transmitters forbuttons, begin with “Programming”― step 1. current, on-market devices as follows: If the indicator light blinks rapidly for 1. Position the end of your hand-heldtwosecondsandthenturnstoa transmitter 2.5―7.5 cm (1―3 inches)constant light, continue with awayfromtheHomeLinkbuttonyou “Programming”steps 5―7tocomplete wish to program while keeping the the programming of a rolling code indicator light in view. equipped device (most commonly a 2. Simultaneously press and hold both thegarage door opener). chosen HomeLink and hand-held 5. At the garage door opener receiver transmitter buttons. Do not release the(motor-head unit) in the garage, locate buttons until step 3 has been the “learn” or “smart” button. This can completed. usually be found where the hanging NOTE antenna wire is attached to the motor- Somegateoperators and garage dooropenershead unit. mayrequire you to replace this Programming6. Firmly press and release the “learn” or Step 2 with procedures noted in the “Gate“smart” button. (The name and color of Operator/Canadian Programming” section.the button may vary by manufacturer.) 3. After the HomeLink indicator lightNOTE changes from a slow to a rapidly There are 30 seconds in which to initiate step blinking light, release both the 7. HomeLinkandhand-heldtransmitter buttons. 7. Return to the vehicle and firmly press, hold for two seconds and release the NOTE programmed HomeLink button. Repeat If the HomeLink indicator light does notthe “press/hold/release” sequence a change to a rapidly blinking light, contactsecond time, and, depending on the HomeLinkatwww.homelink.comorcall1- brand of the garage door opener (or 800-355-3515 for assistance. other rolling code equipped device), 4. Firmly press and hold the programmedrepeat this sequence a third time to HomeLinkbuttonfor five seconds, and complete the programming process. then release it. Perform this operationHomeLinkshouldnowactivate your two times to activate the door. If therolling code equipped device. door does not activate, press and holdNOTE the just-trained HomeLink button andTo program the remaining two HomeLink observe the indicator light. buttons, begin with “Programming”― step 1. If the indicator light stays on constantly, programmingiscompleteandyour For questions or comments, please contact device should activate when the HomeLinkatwww.homelink.comor1- HomeLinkbuttonispressed and released.800-355-3515. 5-62 Form No.8EN7-EA-14E

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders