owners manual Subaru Outback

all ratings: 0 average rating: 5

3-58 Instruments and controls/Mirrors recognizetheHomeLink®WirelessControl 2. Press and hold the two outer System and your garage door opener HomeLink® buttons (button 1 and button should activate when the HomeLink® 3) until the HomeLink® indicator light button is pressed. begins to flash (after approximately 20 seconds). Then release both buttons. !Programming for entrance gates 3. Hold the end of the entrance gate’s/ and garage door openers in garage door opener’s hand-held transmit- Canada ter between 1 and 3 inches (25 and 76 1. Unplug the motor of the entrance gate mm)awayfromtheHomeLink®buttonyou or garage door opener from the outlet. wish to program. ® 4. Press and hold the desired HomeLink NOTE button. If any of the HomeLink® buttons are 5. Press and release (“cycle”) the hand- 1) Training button already programmed for other devices, held transmitter button every 2 seconds 2. Press the training button on the skip step 2 because it clears the until step 6 is complete. garage door opener motor head unit memory of all three buttons. 6. When the indicator light flashes slowly (which activates the “training light” on the and then rapidly after several seconds, unit). Proceed to step 3 within 30 seconds. release both buttons. 3. Insidethevehicle,firmly press, hold for 7. Plug the motor of the entrance gate/ 2 seconds and release the HomeLink® garage door opener to the outlet. button that was programmed in the pre- 8. Test your entrance gate/garage door vious section. Press and release the opener by pressing the programmed button a second time to complete the HomeLink® button. programming procedure. NOTE ! Operating the HomeLink® Wire- less Control System Some garage door openers may re- Once programmed, the HomeLink® Wire- quire you to do the above press-hold- less Control System can be used to release sequence a third time to com- remote-control the devices to which its plete the programming. 1) HomeLink® button 1 buttons are programmed. To activate a 4. The garage door opener should now 2) HomeLink® button 2 device, simply press the appropriate but- 3) HomeLink® button 3

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders