Subaru Impreza II 2 GD owners manual page 204

text version of content this owner's manual page from owners manual to the vehicle Subaru Impreza, year of production 2001 - 2007:

A1900BE-A.book Page 7 Friday, June 17, 2005 5:40 PM Starting and operating 7-7 Starting the engine If the engine does not start, try the follow-NOTE ing. The engine may be difficult to start 1)Turn the ignition switch to the “OFF” when the battery has been disconnect- position and wait for at least 10 sec- ed and reconnected (for maintenance onds. After checking that the parking Do not operate the starter motor or other purposes). This difficulty is brake is firmly set, turn the ignition continuously for more than ten sec- switch to the “START” position while de-caused by the electronically controlled onds. If the engine fails to start after throttle’s self-diagnosis function. To pressing the accelerator pedal slightly operating the starter for five to ten overcome it, keep the ignition switch in (approximately a quarter of the full seconds, wait for ten seconds or stroke). Release the accelerator pedal the “ON” position for approximately 10 more before trying again. as soon as the engine starts. seconds before starting the engine. Manual transmission vehicle 2)If this fails to start the engine, turn theAutomatic transmission vehi- ignition switch back to the “OFF” posi- cle 1. Apply the parking brake. tion and wait for at least 10 seconds. 2. Turn off unnecessary lights and acces-Then fully depress the accelerator ped-1. Apply the parking brake. al and turn the ignition switch to the sories. 2. Turn off unnecessary lights and acces- 7 “START” position. If the engine starts, 3. Press the clutch pedal to the floor and sories. quickly release the accelerator pedal.3. Shift the selector lever to the “P” or “N” shift the shift lever into neutral. Hold the clutch pedal to the floor while starting the3)If this fails to start the engine, turn theposition (preferably “P” position). engine. ignition switch again to the “OFF” posi-The starter motor will only operate when tion. After waiting for 10 seconds or The starter motor will only operate when the select lever is at the “P” or “N” position. longer, turn the ignition switch to the the clutch pedal is pressed fully to the 4. Turn the ignition switch to the “ON” po- “START” position without depressing floor. sition and check the operation of the warn- 4. Turn the ignition switch to the “ON” po-the accelerator pedal. ing and indicator lights. Refer to the sition and check the operation of the warn-4)If the engine still refuses to start, con-“Warning and indicator lights” section tact your nearest SUBARU dealer for ing and indicator lights. Refer to the (chapter 3). assistance. 5. Turn the ignition switch to the “START” “Warning and indicator lights” section (chapter 3). 6. Confirm that all warning and indicator position without depressing the accelera- lights have gone off after the engine has 5. Turn the ignition switch to the “START” tor pedal. Release the key immediately af- started. The fuel injection system auto- position without depressing the accelera- ter the engine has started. tor pedal. Release the key immediately af-matically lowers the idle speed as the en-If the engine does not start, try the follow- ter the engine has started. gine warms up. – CONTINUED –

owners manual Subaru Impreza

owners manual Subaru Impreza - year of production: 2001, 2002, 2003, 2004, 2005, 2006, 2007 - Subaru Impreza II 2 GD owners manual EN