owners manual Skoda Octavia

all ratings: 0 average rating: 5

s43s.1.book Page 201 Thursday, May 13, 2010 1:21 PM Inspecting and replenishing201 Note Losses can only occur through the pressure relief in the cap of the coolant expansion bottle which is completely free of leaks if the coolant boils as a result of overheating On vehicles which are fitted with an indepe ndent auxiliary heating and ventilation, the and is forced out of the cooling system. volume of the coolant is greater by approx. 1 ltr. Inspecting the coolant level WARNING Read and observe the warning notes page197, “Working in the engine compartment” before working in the engine compartment. Caution One should contact a specialist garage as s oon as possible if the source of overheating itself cannot be determined and removed, since there may be grave damage to the engine. Fig. 164 Engine compartment: Coolant Replenishing the coolant expansion bottle – Switch the engine off. The coolant expansion bottle is located in the engine compartment on the right.– Allow the engine to cool down. – Switch the engine off. – Place a cloth over the cap of the coolant expansion reservoir  fig. 164 and – Open the bonnet page196. unscrew the cap carefully by turning it to the left . – Check the level of coolant in the coolant expansion bottle  fig. 164. The coolant –Top up the coolant. level when the engine is cold must lie between the b (MIN) and a (MAX) mark- A A – Screw the cap tight until it is heard to lock. a ings. The level may also rise slightly above the (MAX) marking when the engine A is warm. The coolant which you use for replenishing the system, must comply with one specific If the coolant level in the reservoir is too low, this is indicated by the warning light in specification page200. Do not use an alternative additive if the coolant additive the instrument cluster page31, “Coolant temperature/coolant level ”. We never-G13 is not available in exceptional cases. Just top up the system with water and as soon theless recommend inspecting the coolant level directly at the reservoir from time to as possible arrange adjustment to correct the mixing ratio of water and coolant addi- time. tive again by a specialist garage. Loss of coolant Only use fresh coolant for topping up the system. A loss of coolant is first and foremost an indication of a leak in the system. You should Do not fill up over the “MAX” marking! Excess coolant which is heated up is forced out not merely top up the coolant in the reservoir. It is also important to have the cooling of the cooling system through the pressure relief valve in the cap of the coolant system inspected without delay by a specialist garage.compensation bottle. Wait until the engine has cooled down for a system which has suffered a major loss of coolant before pouring in coolant. This is necessary to avoid engine damage. Using the systemSafety Driving Tips General MaintenanceBreakdown assistanceTechnical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders