owners manual Saab 9-3

all ratings: 0 average rating: 5

198 Car care (80°C). This can be achieved by driving Coolant the car for about 30 min on the open road. 2 With the engine idling, move the selector WARNING lever to D and wait for at least 15seconds. Next, move the selector • Proceed with caution if the radiator is lever to R and wait for 15 seconds again. boiling when you open the hood. Finally, move the selector lever to P. Let Never remove the expansion-tank the engine idle. filler cap when the radiator is boiling. 3 Wipe the dipstick clean with a lint-free Loosen the cap carefully, and let the cloth and put it back. engine cool before removing the cap. 4 With the fluid at normal temperature, the • The cooling system is pressurized – level should be between the MAX and hot coolant and vapor can escape MIN marks on the dipstick. Top up, as when the filler cap is released. Coolant expansion tank necessary, with Texaco Texamatic Dexron III automatic-transmission fluid, The expansion tank is transparent, to facili- adding it through the dipstick pipe. The tate checking. The level must be a little Coolant distance between the MIN and MAX under the mark ”KALT – COLD” on the tank The cooling system is filled at the factory marks on the dipstick corresponds to a when the engine is cold. If the SID message with coolant containing a 50% concentra- volume of approximately 0.4 qts "FILL COOLANT FLUID" is displayed, the tion of a combined antifreeze and corrosion (0.4 litre). level in the expansion tank should be checked. Top up as necessary with equal inhibitor. A weaker mixture will result in NOTE parts of clean water and coolant. Use only reduced anticorrosion protection. For pro- coolant approved by Saab. tection against freezing in very cold If there is a burnt smell or the fluid is black, If the expansion tank is empty when coolant weather, a stronger concentration will be change the fluid as soon as possible. is added, run the engine to normal temper- needed. ature and top up again, as necessary. A 60% concentration of antifreeze will pro- If the outside temperature is below 50°F vide protection at temperatures down to (10°C), the fluid will not reach the specified -58 F (-50°C). temperature of 175°F (80°C). In this case, the correct fluid level may be 0.8 in (20 mm) below the MAX mark.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders