owners manual Nissan Rogue

all ratings: 0 average rating: 5

Black plate (200,1) Accelerator downshift seconds. Then turn the switch back to the —In D position — ON position. The vehicle should return to For passing or hill climbing, fully depress theits normal operating condition. If it does accelerator pedal to the floor. This shifts thenot return to its normal operating condi- transmission down into a lower gear, dependingtion, have a NISSAN dealer check the on the vehicle speed. transmission and repair if necessary. High fluid temperature protection modeWARNING This transmission has a high fluid temperatureWhen the high fluid temperature pro- protection mode. If the fluid temperature be- comes too high (for example, when climbingtection mode or fail-safe operation steep grades in high temperature with heavyoccurs, vehicle speed may be gradually loads, such as when towing a trailer), enginereduced. The reduced speed may be power and, under some conditions, vehiclelower than other traffic, which could speedwill be decreased automatically to reduceincrease the chance of a collision. BeSSD0667 the chance of transmission damage. Vehicleespecially careful when driving. If ne-Shift lock release speed can be controlled with the acceleratorcessary, pull to the side of the road at aIf the battery charge is low or discharged, the pedal, but the engine and vehicle speed may besafe place and allow the transmissionselector lever may not be moved from the P limited. to return to normal operation, or have it(Park) position even with the brake pedal Fail-safe repaired if necessary. depressedandtheselectorleverbutton pushed. If the vehicle is driven under extreme Tomovetheselector lever, release the shift lock. conditions, such as excessive wheel spin- The selector lever can be moved to the N ning and subsequent hard braking, the (Neutral) position. However, the steering wheel fail-safe system may be activated. The MIL will be locked unless the ignition switch is turned may illuminate to indicate the fail-safe to the ON position. This allows the vehicle to be mode is activated. (See “Malfunction In- moved if the battery is discharged. dicator Light (MIL)” in the “2. Instruments andcontrols” section.) This will occur even To release the shift lock, perform the following ifall electrical circuits are functioning procedure: properly. In this case, turn the ignition 1. Turn the ignition switch to the LOCK switch to the OFF position and wait for 10 5-16 Starting and driving Model "S35-D" EDITED: 2007/ 12/ 19

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders