or
owners manual Alfa Romeo 33
owners manual Alfa Romeo 33 - year of production: 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995 - Alfa Romeo 33 owners manual EN
Document:
pdf (12.9 MB) 378 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle Alfa Romeo 33, year of production 1983 - 1995:
FRONT SUSPENSION
Remove wheel from the opera-
Refit remaining parts of strut.as-2.
CHECKS AND INSPECTIONS
tive side.
Clean all the components. sembly complying with sequence
shown on figure. 3. Loosen and remove shaft secur-
j’
.;-’ Self-lubricating bush ing nut (wheel side).
4. Detach constant-speed
Check self-lubricating bushesembod- joint
from differential drive shaft by
;;,,,ied in strut lower cap retainers for
loosening the six securing screws
’ : signs of excessive wear which are
showed by metallic dust appearing and remove shaft.
,,-on’bush working surface. 5. Remove nut securing semi-trail-
ing link ball joint pin@ to hub
Shock absorber support and withdraw pin using tool
If required verified setting data re- A.3.0157.
levant to shock absorber built-in 6. Loosen bolt@ securing trans-
strut. (Refer to Service Data and verse link @ to engine cross mem-
Specifications-Checks and Inspec- ber @ and bolt@ securing to
tions). semi-trailing link@ , then with-
draw the removing transverse link.
Replace shock absorber in case they 7. Loosen bolt@ securing semi-
are removed because of inefficiency trailing link to body and remove the
or oil leakages are detected. link.
Springs Spring lower and upper caps should
be those corresponding with the-side
Visually check springs for anomalous.(righthand .or l&hand) to which
signs. , strut is installed.
Rubber parts INSTALLATION
Replace rubber parts if deformed,
damaged or aged. 1, Install strut in the reverse order
of removal and tighten following
parts to the specified torque:
ASSEMBLY
@ : Tightening torque
1. Lubricate seal ring and thrust
Screw securing hub support to
bearing of spring lower cap0 1 Cross member5 Bolt
retainer with grease (AGIP Fl Grease strut bracket 2 Bolt 6 Semi-trailing link
39t48 N-m 3 Transverse link7Bolt
33 FD,IP Atitogrease FD). (4 + 4.9 kg-m 4 Fin
Refit all parts of retainer to strut
complying with direction and order 28.9: 35.43ft-lb)
marked during disassembly. 8. If required, after checking flex-
Nut securing strut to body
2. If previously removed, refit tool 12+ 15 N-m ible joints: remove flexible joints
A.2.0251 to spring@ and lower (I,2 + I,5 kg-m from semi-trailing links and trans-
cap @ with tool clamped in vice; verse jinks by means of proper tool.
compress spring so that subsequent 8,84 + 11ft.lb)
assembly procedure can be carried
out. Nut, steering tie rod ball joint
on bracket lever
39 + 48 N-m
A.2.0251 (4 + 4.9 kg-m
1 28.9 + 35.43ft.lb)
ro
TRANSVERSE AND
SEMI-TRAILING LINK
REMOVAL
1. Place car on lift. Support front
of vehicle on stands sited in adjacent
-position to jacking points and block
1 Lower cap 2 Spring rear wheels by hand brake.
May 1983 21-8
Download PDF
Click here to download a pdf file with an instruction manual for Alfa Romeo 33
year of production from: 1983
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Alfa Romeo 33 owners manual
pages 192 - 198
Alfa Romeo 33 owners manual
page 195 / 378
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF
Others owner's manuals for this model: