manual Audi R8 I 1 owners manual page 187

text version of content this owner's manual page from owners manual to the vehicle Audi R8, year of production 2006 - 2015:

document_0900452a816e6cc9.book Seite 185 Mittwoch, 21. Februar 2007 1:32 13 Self-help 185 Tightening wheel bolts Jump-starting – Fit the box spanner as far as it will go over the wheel Before starting the engine 5) bolt . If necessary, the engine can be started by connecting it to – Grip the box spanner as close to the end as possible and the battery of another vehicle. tighten the bolt firmly by turning clockwise. If the engine should ever fail to start because of a discharged Have the tightening torque of the wheel bolts checked as soon as battery, the battery can be connected to the battery of another possible with a torque wrench. The correct tightening torque is vehicle to start the engine. Suitable jump leads are required. 120 Nm. Both batteries must be rated at 12 Volts. The capacity (Ah) of the The inflation pressure must be checked as soon as possible. booster battery should not be significantly lower than that of the Put the tools and jack back in the luggage compartment. discharged battery. Jump leads WARNING The jump leads must be heavy enough to carry the starter current. Refer to the details given by the manufacturer. The wheel bolts must not be loosened – this would cause a safety Only use jump leads with insulated battery clamps. risk. Positive cable – usually red Note Negative cable – usually black • Do not use the hexagonal socket in the screwdriver handle to loosen or tighten the wheel bolts. WARNING • If you notice that the wheel bolts are corroded and difficult to • When it is discharged the battery can freeze at temperatures turn, they must be replaced before having the tightening torque around0°C. A frozen battery must first be thawed out before checked. connecting the jump leads, as it could otherwise explode. • In the interest of safety, drive at moderate speeds until the tight-• Please note the safety warnings referring to working in the ening torque of the wheel bolts has been checked. engine compartment ⇒page155. Note • There must be no contact between the two vehicles as otherwise current could flow as soon as the positive terminals are connected. • The discharged battery must be properly connected to the 5)An adapter is required to tighten the anti-theft wheel bolts ⇒ page 182.vehicle's electrical system. Controls Safety Driving tips General maintenance Self-help Technical data

owners manual Audi R8

owners manual Audi R8 - year of production: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015 - Audi R8 I 1 owners manual EN