owners manual Chevrolet Corvette

all ratings: 0 average rating: 5

Chevrolet Corvette Owner Manual (GMNA-Localizing-U.S./Canada/Mexico- Black plate (6,1) 7576293) - 2015 - crc - 6/17/14 9-6 Driving and Operating Z51 and Z06 Only: Check the oil Brake Fluid Wheel Alignment level often during track events and Replace existing brake fluid with a competitive driving and keep the qualified high performance brake {Caution level at or near 0.5 L (0.5 qt) abovefluid from a sealed container. Brake the upper mark that shows the fluid with a dry boiling point >279°C Using these wheel alignment proper operating range on the (534°F) is qualified. If high settings may cause excessive tire engine oil dipstick. After the performance brake fluid is used, wear. Only use these wheel competitive driving, remove excess replace it with GM approved brake alignment settings for racing or oil so that the level on the dipstick isfluid before driving on public roads.competitive driving. Excessive tire not above the upper mark that If high performance brake fluid is in wear is not covered under the shows the proper operating range. the vehicle and the age of the brake vehicle warranty. Except Z51 and Z06: Additional oil fluid is over a month old or fill above the upper mark on the unknown, replace the brake fluid If the vehicle is equipped with the dipstick is not recommended for before track events and competitive Z51 package or is a Z06, the racing track events or other competitive driving. Do not use silicone or and competitive driving wheel driving. Check the oil level often DOT-5brake fluids. alignment settings should be set as during racing or other competitive Load Limit follows: driving and keep the level at or near the upper mark that shows the Z51 Only: Limit vehicle load to the Alignment should only be done by proper operating range on the driver only, with no other cargo. adjusting the lower control arm cam engine oil dipstick. After the Inflate tires to 180 kPa (26 psi) andbolts and by removing a maximum competitive driving, remove excess drive at a maximum speed of of one washer between the upper oil so that the level on the dipstick is280 km/h (174 mph). control arms and frame. not above the upper mark that Z06 Only: Limit vehicle load to the Alignment values are targets, see shows the proper operating range. driver only, with no other cargo. your dealer for tolerances. Inflate tires to 180 kPa (26 psi) andFront (per corner) drive at a maximum speed of 296 km/h (184 mph). . Caster: +7.0 degrees

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders