owners manual Jeep Patriot

all ratings: 0 average rating: 5

182 UNDERSTANDINGTHEFEATURESOFYOURVEHICLE 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)•If the indicator light stays on constantly, program- away from the HomeLink button you wish to pro-mingiscompleteandthegaragedoor/deviceshould gramwhile keeping the HomeLink indicator light inactivate when the HomeLink button is pressed. view. •Toprogramthe two remaining HomeLink buttons, 3. Continue to press and hold the HomeLink button,repeat each step for each remaining button. DO NOT while you press and release (“cycle”), your hand-helderase the channels. transmitter every two seconds until HomeLink hasIf you unplugged the garage door opener/device for successfully accepted the frequency signal. The indi-programming, plug it back in at this time. cator light will flash slowly and then rapidly whenReprogramming A Single HomeLink Button fully trained. 4. Watch for the HomeLink indicator to change flashToreprogramachannelthathasbeenpreviouslytrained, rates. When it changes, it is programmed. It may takefollow these steps: up to 30 seconds or longer in rare cases. The garage1. Cycle the ignition to the ON/RUN position. doormayopenandclosewhileyouareprogramming. 2. Press and hold the desired HomeLink button until 5. Press and hold the programmed HomeLink buttonthe indicator light begins to flash after 20 seconds. Do and observe the indicator light.not release the button.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders