owners manual Seat Altea

all ratings: 0 average rating: 5

Driving173 Activation The system is activated by engagement of the reverse gear. A brief acoustic WARNING signal confirms the activation and correct function of the system.• The sensors have blind spots in which obstacles may not be detected. Reversing • Always look out for small children and animals because the system will The distance warning will begin as soon as an obstacle is detected by the not always detect them. Always pay attention when reversing to avoid acci- system. The frequency of the bleeps emitted by the system will increase dents. rapidly as the vehicle approaches the obstacle.• The parking aid is not a replacement for driver awareness. The driver must take full responsibility for parking and other manoeuvres. Within a short distance of about 25 cm, a continuous signal sounds (stop signal). The driver should not reverse any further. Caution Trailer towing • Please note that low obstacles detected by the system may no longer be For vehicles fitted with a tow bar by th e manufacturer, the parking aid system registered by the sensors as the car moves closer, so the system will not give will not be activated by the engagement of the reverse gear when pulling a any further warning. Certain kinds of obstacles (such as wire fences, chains, trailer, as the trailer's electric connecter will be plugged into the vehicle.thin posts or trailer draw bars, high kerbs or painted railings etc) may not To avoid system malfunctions, when not driving with a trailer, remove the always be detected by the system, so there is a risk of damaging the vehicle trailer hitch. in such cases. • Obstacles with uniform edges and bumps may not be detected immedi- Possible faults ately by the system due to their geometry. Take special care around this type If a continuous bleep sounds for some seconds when the reverse gear is of obstacle such as corners, rectangular objects, etc, these can cause engaged, this indicates that there is a fault in the parking aid system.damage to the vehicle. If the fault continues until the ignition is turned off, the acoustic signal • Be especially carefully when manoeuvring into a corner between two warning of the fault will not be emitted every time the system is reactivated perpendicular walls. Survey the approach of the wall to the side of the vehicle (by engaging the reverse gear). Thus, the system ready indication will not (using the mirrors) sound either. Have the fault repaired by an Authorised Service Centre as soon • The parking aid system does not replace use of the mirrors for manoeu- as possible. vres. If there is no ready signal or no acou stic warning signal then the parking aid • Distant ultra-sonic sources (hammers, tyres, construction machinery, loudspeaker is faulty and may not warn of obstacles.other vehicles with PDC) may interfere with the operation of the system. To ensure that the system works properly, the sensors must be kept clean and • Periodic cleaning of the sensors, take care not to damage or scratch them. free of ice and snow. When cleaning with high pressure washers or steam cleaners, the sensors should be sprayed for only a very short period and from a distance of more than 10 cm. Safety First Operating instructionsTips and MaintenanceTechnical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders