owners manual Skoda Octavia

all ratings: 0 average rating: 5

s43s.1.book Page 173 Thursday, May 13, 2010 1:21 PM Intelligent Technology 173  one wheel per axle was changed. Note Basic setting of the system The tyre pressure monitoring system: After changing the tyre inflation pressures, after changing one or several wheels, the  does not replace the regular tyre inflation pressure control, because the system position of a wheel on the vehicle (e.g. exchanging the wheels between the axles) or cannot detect an even pressure loss, when the warning light lights up while driving, a basic setting of the system must be  cannot warn in case of very rapid tyre inflation pressure loss, e.g. in case of sudden carried out as follows. tyre damage. In this case carefully bring the vehicle to a standstill without sudden  Inflate all tyres to the specified inflation pressure  page 208.steering movements and without sharp braking.  Switch on the ignition.  In order to ensure a proper functioning of the tyre inflation pressure-control  Press button   page172, fig.151 for more than 2 seconds. While pressing system, it is necessary to carry out the basic setting again every 10 000 km or 1x a the button, the warning light  lights up. At the same time the memory of the system year. is erased and the new calibration is started, which is confirmed with an audible signal and then the warning light  goes out. Diesel particle filter* (diesel engine)  If the warning light  does not go out after the basic setting, there is a fault in the system. Have the vehicle inspected by your nearest specialist garage.In the diesel particle filter the resu lting soot particles are collected and burnt during the combustion of diesel fuel. Warning light  lights up If the tyre inflation pressure of at least one wheel is insufficiently inflated in comparison to the stored basic value, the warning light   lights up. Warning light  flashes If the warning light flashes, there is a system fault. Have the vehicle inspected by your nearest specialist garage. WARNING  When the warning light  lights up, immediately reduce the speed and avoid sudden steering and brake manoeuvres. Please stop the vehicle without Fig. 152 Vehicle data sticker delay at the nearest possible stop and inspect the tyres and their inflation pres- sures. Code 7GG, 7MB or 7MG on the vehicle data sticker, see fig. 152, indicates that your  The driver is responsible for the correct tyre inflation pressures. For this vehicle is equipped with a diesel particle filter. The vehicle data sticker is located on reason, the tyre inflation pressures must be checked regularly.the floor of the luggage compartment and is also stated in the Service schedule.  Under certain circumstances (e.g. sporty style of driving, wintry or unpaved The diesel particle filter filters the soot particles completely from the exhaust. The soot roads) the warning light  can be delayed or does not light up at all.is collected in the diesel particle filter and burnt regularly. To assist this procedure, we  The tyre pressure monitoring system does not take away the responsibility recommend not to drive regularly over short distances. from the driver for the correct tyre inflation pressure. Using the systemSafety Driving Tips General MaintenanceBreakdown assistanceTechnical Data

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders