owners manual Ford Ranger

all ratings: 0 average rating: 5

Driving If the fuse is not blown and the brakelamps are working properly, the following procedure will allow you to move the gearshift lever from P (Park): 1. Apply the parking brake, and turn the ignition to the on position. 2. Remove the lower trim panel under the steering column. Make sure not disturb the wires on the electrical connector. 3. Locate the BSI solenoid underneath the steering column. 4. With your hand, pull back on the solenoid, and at the same time, shift the transmission into N (Neutral). 5. Start the vehicle. See your authorized dealer as soon as possible if this procedure is used. WARNING:Donot drive your vehicle until you verify that the brakelamps are working. WARNING:Always set the parking brake fully and make sure the gearshift is latched in P (Park). Turn the ignition to the lock position and remove the key whenever you leave your vehicle. WARNING:If the parking brake is fully released, but the brake warning lamp remains illuminated, the brakes may not be working properly. See your authorized dealer. AUTOMATICTRANSMISSIONOPERATION(IF EQUIPPED) Driving with a 5–speed automatic transmission (if equipped) This vehicle is equipped with an adaptive transmission shift strategy. Adaptive shift strategy offers the optimal transmission operation and 174 2010 Ranger (ran) Owners Guide, 2nd Printing USA(fus)

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders