or
owners manual Mazda 6
owners manual Mazda 6 - year of production: 2002, 2003, 2004, 2005, 2006, 2007 - Mazda 6 I 1 Atenza owners manual EN
Document:
pdf (3.23 MB) 340 pages
all ratings: 0
average rating: 5
text version of content this owner's manual page
from owners manual to the vehicle Mazda 6, year of production 2002 - 2007:
Driving Your Mazda
Switches and Controls
qProgrammingtheHomeLink 4. After the HomeLink indicator light
System changes from a slow to a rapidly
blinking light, release both the
CAUTION HomeLinkandhand-heldtransmitter
buttons.
Whenprogrammingagaragedoor
opener or a gate, disconnect the powerNOTE
to these devices before performing If the HomeLink indicator light does
programming, as continuous operation not change to a rapidly blinking light,
of the devices could damage the motor.contact HomeLink at
www.homelink.comorcall 1-800-355-
TheHomeLinksystemprovides3buttons 3515 for assistance.
which can be individually selected and
programmed using the transmitters for5. Press and hold the just-trained
current, on-market devices as follows: HomeLinkbuttonandobservethe
1. Press and hold the two outer indicator light.
HomeLinkbuttons (buttons one and If the indicator light stays on constantly,
three) - releasing only when the programmingiscompleteandyour
indicator light begins to flash (after 20device should activate when the
seconds). Do not hold the buttons forHomeLinkbuttonispressed and released.
longer than 30 seconds and do not
repeat step 1 to program a second and/
or third hand-held transmitter to theNOTE
remaining two HomeLink buttons. Toprogramthe remaining two
2. Position the end of your hand-held HomeLinkbuttons, begin with
transmitter 2.5―7.5 cm (1―3 inches) “Programming” - step 2. Do not repeat
awayfromtheHomeLinkbuttonyou step 1.
wish to program while keeping the
indicator light in view. If the indicator light blinks rapidly for
3. Simultaneously press and hold both thetwosecondsandthenturnstoa
chosen HomeLink and hand-held constant light, continue with
transmitter buttons. Do not release the“Programming”steps 6―8tocomplete
buttons until step 4 has been the programming of a rolling code
completed. equipped device (most commonly a
garage door opener).
NOTE 6. At the garage door opener receiver
(motor-head unit) in the garage, locate
Somegateoperators and garage door the “learn” or “smart” button. This can
openers may require you to replace thisusually be found where the hanging
Programming Step 3 with procedures antenna wire is attached to the motor-
noted in the “Gate Operator/Canadian head unit.
Programming” section.
5-46
Download PDF
Click here to download a pdf file with an instruction manual for Mazda 6
year of production from: 2002
Do you prefer pdf format?
Find out how to download
Enter the code to download PDF file:
All pages in one PDF file!
How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.
:
Mazda 6 I 1 Atenza owners manual
pages 167 - 173
Mazda 6 I 1 Atenza owners manual
page 170 / 340
this site is maintained by advertising - for view instructions, turn off ad blocking in your browser
Download PDF