owners manual Subaru Tribeca

all ratings: 0 average rating: 5

3-40 Instruments and controls ! Electronic compass display!Compasscalibration By pressing the multifunction button for 31. For optimum calibration, switch off all to 6 seconds, the compass display isnonessential electrical accessories (rear toggled on or off. When the compasswindow defogger, heater/air conditioning display is on, an illuminated compasssystem, spotlight, etc.) and ensure all reading will appear on the mirror.doors are shut. Using the electronic compass properly,2. Drive to an open, level area away from the following compass zone adjustmentlarge metallic objects or structures and and compass calibration will be neces-make certain the ignition switch is in the sary. “ON” position. !Compasszoneadjustment 3. Press and hold the multifunction but- ton for 9 to 12 seconds, and then release Themirror has a photosensor attached on1. The compass zone has been set toit. The compass will enter the calibration both the front and back sides. Use carezone “8” at the time of shipment from themode, then “C” and the direction will be not to cover the sensors with stickers, orfactory. Refer to the “Compass calibrationdisplayed. other similar items. Periodically wipe thezones” map, which is attached to the end4. Drive slowly in a circle until “C” sensors clean using a piece of dry softof this manual to verify that the compassdisappears from the display. Driving in cotton cloth or an applicator.zone setting is correct for your geographi-two or three circles might be necessary. cal location. The compass is now calibrated. NOTE 2. Press and hold the multifunction but-5. Further calibration may be necessary When cleaning the mirror, use a paperton for 6 to 9 seconds, and then release it.should outside influences cause the com- towel or similar item dampened withThe zone number will be displayed.pass to read inaccurately. You will notice glass cleaner. Do not spray glass3. Press the multifunction button repeat-anyoutsideinfluenceif the compasstends cleaner directly on the mirror surface.edly to cycle the display through allto read in only one particular direction. Bydoingso,the sprayed glass cleanerpossible zone settings. Stop cycling whenShould you encounter this situation, return could enter the inside of the mirrorthe correct zone number for your locationto step 1 of the above procedure and housing. That may cause a malfunctionis displayed.recalibrate the compass. in the mirror. 4. Releasing the button for 3 seconds will exit the zone setting mode.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders