owners manual Volvo XC60

all ratings: 0 average rating: 5

INSTRUMENTS AND CONTROLS || 2. Aim the remote control towards the 4. Press and release the button on the original ® remote control every other second until the HomeLink button to be programmed and hold it approx. 2-8 cm (approx. 1-3 inches) indicator lamp has changed from flashing from the button. Do not obstruct the indicator yellow once per second to either flashing ® green 10 times per second or illuminating in lamp on HomeLink . Note: The ability of some remote controls to a constant green glow. 5. ® ® Depress the programmed HomeLink button program HomeLink is improved at a dis- tance of approx. 15-20 cm (approx. 6-12 and check the indicator lamp. inches). Bear this in mind if you encounter > Constant green glow: If the indicator problems during programming. lamp illuminates in a constant green glow, 6. 36 Locate programming button on the 3. Press and hold the button on the original programming is complete. The garage receiver for the garage door or similar. It is remote control to be programmed on door, gate or similar should now be acti- normally located near the antenna bracket on vated when the programmed button is the receiver. ® HomeLink and keep an eye on the indicator depressed. lamp. Do not release the button until the 7. Depress and release the receiver€s program- indicator lamp has switched from flashing Flashes green 10 times per second: ming button. Step 8 must be completed yellow once per second to either flashing Depress the button being programmed, within 30 seconds of the button being green 10 times per second or illuminating in hold it depressed for 2 seconds and depressed. a constant green glow. The button on the then release it. Repeat the sequence of 8. Depress the button being programmed, hold remote control can be released once the pressing/holding/releasing a second time it depressed for 2 seconds and then indicator lamp flashes or illuminates in green. and, depending on the receiver model, release it. Repeat the sequence of press- Note: For some receivers, programming step even a third time. Programming should ing/holding/releasing a second time and, 3 may need to be replaced with the instruc- now be complete and the garage door, depending on the receiver model, even a tions in step 4. gate or similar should now be activated third time. Programming is now be com- when the programmed button is plete and the garage door, gate or similar depressed. should now be activated when the pro- If the receiver is still not activated: grammed button is depressed. Continue with programming steps 6-8 to complete programming. 34 Applies to certain markets. 35 ® See section "HomeLink *" for the location of buttons and indicator lamp. 36 Button designation and colour vary depending on manufacturer. 160

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders