owners manual Subaru Outback

owners manual Subaru Outback - year of production: 2009, 2010, 2011, 2012, 2013, 2014 - Subaru Outback Legacy IV 4 owners manual EN

Document: pdf (18.3 MB) 474 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Subaru Outback, year of production 2009 - 2014:

3-42 Instruments and controls NOTE 6. When the indicator light flashes slowly Some garage door openers may re- and then rapidly after several seconds, quire you to do the above press-hold- release both buttons. release sequence a third time to com- 7. Plug the motor of the entrance gate/ plete the programming. garage door opener to the outlet. 4. The garage door opener should now 8. Test your entrance gate/garage door recognize the HomeLink®WirelessControl opener by pressing the programmed System and your garage door opener HomeLink® button. should activate when the HomeLink® button is pressed. ! Operating the HomeLink® Wireless Control System !Programmingforentrancegatesand Once programmed, the HomeLink® Wire- garage door openers in Canada 1) HomeLink® button 1 less Control System can be used to ® button 2 remote-control the devices to which its 1. Unplug the motor of the entrance gate 2) HomeLink or garage door opener from the outlet. 3) HomeLink® button 3 buttons are programmed. To activate a device, simply press the appropriate but- NOTE 2. Press and hold the two outerton.Theindicatorlightilluminates, indicat- If any of the HomeLink® buttons are HomeLink® buttons (button 1 and button ing that the signal is being transmitted. already programmed for other devices, 3) until the HomeLink® indicator light begins to flash (after approximately 20 !Programming other devices skip step 2 because it clears theseconds). Then release both buttons. To program other devices such as door memory of all three buttons. locks, home lighting and security systems, 3. Hold the end of the entrance gate’s/ garage door opener’s hand-held transmit- contact HomeLink® at www.homelink.com ter between 1 and 3 inches (25 and 76 or call 1-800-355-3515. mm)awayfromtheHomeLink®buttonyou !Reprogrammingasingle HomeLink® wish to program. button 4. Press and hold the desired HomeLink® button. 1. Press and hold the HomeLink® button 5. Press and release (“cycle”) the hand- you wish to reprogram. DO NOT release held transmitter button every 2 seconds the button until step 4 has been com- until step 6 is complete. pleted. 2. When the HomeLink® indicator light

Download PDF

Click here to download a pdf file with an instruction manual for Subaru Outback
year of production from: 2009

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.