owners manual Skoda Superb

all ratings: 0 average rating: 5

Briefly push the rocker button B into the RES position in order to resume the Changing the stored speed  stored speed after the clutch or brake pedal is released. First read and observe the introductory information and safety warn- ings on page ĖĚĚ.  S0AR0-S0OP Increasing the speed with the rocker button B ›Push the rocker button B into the RES » Fig. Ėęĕ on page ĖĚĚ position. Introduction 0he speed will increase continuously, if the rocker button is pressed and held in the RES position. Release the rocker button once the desired speed is reached.0his chapter contains information on the following subjects: 0he set speed is then stored in the memory. Starting/shutting down the engine ĖĚĜ Decreasing the speed using the rocker button B System operating conditions ĖĚĜ 0he stored speed can be reduced by pushing the rocker button B into the Manually activating/deactivating the system ĖĚĝ SE0 » Fig. Ėęĕ on page ĖĚĚ position. Information messages ĖĚĝ 0he speed will decrease continuously, if the rocker button is pressed and held in 0he S0AR0-S0OP system helps you to save fuel while at the same time reducing the SE0 position. Release the rocker button once the desired speed is reached. harmful exhaust emissions and CO emissions. ė 0he set speed is then stored in the memory. 0he function is automatically activated each time the ignition is switched on. If the rocker button is released at a speed of less than ėĚ km/h, the speed is not In the start-stop mode, the engine automatically switches to the vehicle's idle stored and the memory is erased. Once the speed of the vehicle has increased to phase, e.g. when stopped at traffic lights. 0he engine restarts automatically more than ėĚ km/h, the speed must then be stored again by pushing the rocker where necessary. button B into the SE0 position. 0he system can work only if the following basic conditions are met. Increasing the speed with the accelerator ›Depress the accelerator pedal.  0he driver's door is closed. Releasing the accelerator pedal will cause the speed to drop again to the set 0he driver has fastened the seat belt. speed.  0he bonnet is closed.  0he driving speed was higher than ę km.h after the last stop. Decreasing the speed with the brake pedal  No trailer is coupled. 0he speed can also be reduced by depressing the brake pedal, which temporarily  deactivates the system » page ĖĚě. 3ARNING ■ 0he brake servo unit and power steering only operate if the engine is run- 0emporarily deactivating ning. ■ Never let the vehicle roll with the engine switched off. First read and observe the introductory information and safety warn- ings on page ĖĚĚ. CA10ION 0he cruise control system can be temporarily deactivated by pushing the switch A » Fig. Ėęĕ on page ĖĚĚinto the spring-mounted CANCEL position or by depress- Always deactivate the S0AR0-S0OP system before driving through wa- ing the brake or clutch pedal. ter » page ĖęĚ.  0he set speed remains stored in the memory. ĖĚě Driving

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders