owners manual Mazda RX-8

all ratings: 0 average rating: 5

RX-8_8T69-EA-04G_Edition1 Page154 Wednesday, June 9 2004 2:12 PM Black plate (154,1) Driving Your Mazda Switches and Controls qProgrammingtheHomeLink 4. After the HomeLink indicator light System changes from a slow to a rapidly blinking light, release both the CAUTION HomeLinkandhand-heldtransmitter buttons. Whenprogrammingagaragedoor opener or a gate, disconnect the powerNOTE to these devices before performing If the HomeLink indicator light does programming, as continuous operation not change to a rapidly blinking light, of the devices could damage the motor.contact HomeLink at www.homelink.comorcall 1-800-355- TheHomeLinksystemprovides3buttons 3515 for assistance. which can be individually selected and programmed using the transmitters for 5. Press and hold the just-trained current, on-market devices as follows: HomeLinkbuttonandobservethe 1. Press and hold the two outer indicator light. HomeLinkbuttons (buttons one and If the indicator light stays on constantly, three) - releasing only when the programmingiscompleteandyour indicator light begins to flash (after 20device should activate when the seconds). Do not hold the buttons forHomeLinkbuttonispressed and released. longer than 30 seconds and do not repeat step 1 to program a second and/ or third hand-held transmitter to theNOTE remaining two HomeLink buttons. Toprogramthe remaining two 2. Position the end of your hand-held HomeLinkbuttons, begin with transmitter 2.5―7.5 cm (1―3 inches) “Programming” - step 2. Do not repeat awayfromtheHomeLinkbuttonyou step 1. wish to program while keeping the indicator light in view. If the indicator light blinks rapidly for 3. Simultaneously press and hold both thetwosecondsandthenturnstoa chosen HomeLink and hand-held constant light, continue with transmitter buttons. Do not release the“Programming”steps 6―8tocomplete buttons until step 4 has been the programming of a rolling code completed. equipped device (most commonly a garage door opener). NOTE 6. At the garage door opener receiver (motor-head unit) in the garage, locate Somegateoperators and garage door the “learn” or “smart” button. This can openers may require you to replace thisusually be found where the hanging Programming Step 3 with procedures antenna wire is attached to the motor- noted in the “Gate Operator/Canadian head unit. Programming” section. 5-58 Form No.8T69-EA-04G

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders