Lancia Thesis owners manual page 153

text version of content this owner's manual page from owners manual to the vehicle Lancia Thesis, year of production 2001 - 2009:

CONTROLS The set temperatures are shown on– HI function (maximum heating): Knobs for adjusting air tempera- the displays set near the respectivethis is switched on by turning the ture (2, 8 fig. 121 - 1 fig. 122) knobs. temperature knob to the right Press button 16 (MONO - fig. 121 )beyond the maximum value (32 °C). Turn the knobs towards the right It can be independently switched on to automatically align the or towards the left to raise or lower from driver’s side or from (front/back) passenger temperature the air temperature required respec- (front/back) passenger’s side or to the temperature on driver’s side. from both sides (also by selecting the tively in the front left-hand area Consequently the temperature in theMONOfunction). (knob 2 fig. 121) and in the front right-hand area (knob 8 fig. 121) ortwo areas can be set simply by turn- back area (knob 1 fig. 122) of theing the knob on the driver side 2This function can be switched on to passenger compartment. (fig. 121). This function is providedspeed up heating in the passenger to facilitate adjusting the temperaturecompartment by exploiting the sys- in the passenger compartment whentem potential to the maximum. The Since the system controls three areas of the passenger compartment,only the driver is present. The sepa-function employs the maximum rate operation of the set temperaturescoolant temperature while the air the driver and the front/back-seat and air distribution is automaticallydistribution and fan speed are set by passengers can select different tem- reset when knobs 8 (fig. 121) or 1the system according to environ- perature values with a maximum difference accepted by the system of (fig. 122) are turned or button 16mental conditions. In particular, if ° (MONO - fig. 121) is pressed again,the coolant temperature is not suffi- 7 C. when the button led is turned on. cient, the function does not switch Temperature control in the front the fan on at top speed to limit let- Turn the knobs fully to the right or passenger area and in the back pas- ting into air which is not adequately to the left to the end positions HI or senger area is alternated; when the warm. LO, to obtain maximum heating or button led REAR is off, control of cooling, respectively: All the manually settings can be front passenger side is on, but when adjusted when the function is on. button REAR is pressed (button led on) the back control panel is activat- ed. 152

owners manual Lancia Thesis

owners manual Lancia Thesis - year of production: 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009 - Lancia Thesis owners manual EN