owners manual Mitsubishi Lancer

owners manual Mitsubishi Lancer - year of production: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 - Mitsubishi Lancer VIII 8 owners manual EN

Document: pdf (60.3 MB) 434 pages

all ratings: 0 average rating: 5

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Lancer, year of production 2007 - 2016:

ACD (Active center differential system) (if so equipped) ACD control Operation ç In addition, when the control mode is mode changed, the selected mode appears on the Normally, use this control interrupt display screen of the information TARMAC mode. Use this mode for screen in the multi-information display. paved roads. The control mode display will appear on the information screen for a few seconds, and Use this control mode when then the original screen will return. 5 driving on somewhat slip- GRAVEL pery road surfaces, such as CAUTION wet road surfaces and gravel The ACD control mode display may flash roads. under aggressive driving conditions. Use this control mode when NOTE At this time, ACD control is temporarily sus- SNOW driving on slippery road sur- pended in order to protect the ACD device, The control mode can be changed while the faces, such as snow-covered vehicle is moving. but this will not affect normal driving. roads. After the vehicle is driven for a while, if the The selected control mode is stored in mem- ACD control mode display remains on, the ory even if the engine is stopped. ACD control will start operating again. ACD control mode switch However, if a battery terminal is discon- nected, the control mode stored in memory will be erased and the control mode will be When the ignition switch is set to the “ON” ACD warning display set to the “TARMAC” mode. position, operate the AWC switch to change N00545700041 the control mode. When there is a malfunction in the system, ACD control mode display the warning display will appear on the Each time the switch is pushed, the control mode changes in the order “T ARMAC” information screen in the multi-information “GRAVEL”  “SNOW”  “TARMAC”. display. In addition, the ACD control mode display in section (A) will go out at the same time. Example: “TARMAC” mode is selected. The currently selected control mode is dis- played on the multi-information display. 5-84 Features and controls

Download PDF

Click here to download a pdf file with an instruction manual for Mitsubishi Lancer
year of production from: 2007

Do you prefer pdf format?
Find out how to download

Enter the code to download PDF file:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.