owners manual Seat Alhambra

all ratings: 0 average rating: 5

Operation and helps to clean it by recommending a spe-Running-in the engine For the sake of the environment cific gear for driving. It may therefore be nec- The engine needs to be run-in over the first If the engine is run in gently, the life of the essary to drive with the engine at an 1500 km (1000 miles). During its first few engine will be increased and the engine oil exceptionally high speed ››› page 151. hours of running, the internal friction in the consumption reduced. engine is greater than later on when all the WARNING moving parts have bedded down. The recommended gear display is intended as How the vehicle is driven for the firstEnvironmental friendliness a guideline only; it should never replace the 1500 km (1000 miles) influences the future driver's attention to driving carefully. engine performance. Throughout the life ofEnvironmental protection is a top priority in ● Responsibility for selecting the correct gear the vehicle, it should be driven at a moderatethe design, choice of materials and manufac- for each situation continues to lie with the speed – especially when the engine is cold –ture of your new SEAT. driver, for example when overtaking, climb- this will reduce engine wear and increase its ing a hill or towing a trailer. useful life. Never drive at extremely low en-Constructive measures to encourage gine speeds. Always engage a lower gearrecycling For the sake of the environment when the engine works “irregularly”. For the ●Joints and connections designed for easy first 1000 km or 600 miles, please note: Selecting the most appropriate gear for the dismantling situation will help you to save fuel. ● ●Modular construction to facilitate disman- Do not use full throttle. tling ●Do not force the engine above two thirds of Note ●Increased use of single-grade materials. its maximum speed. The recommended gear display is switched ● ●Plastic parts and elastomers are marked in Do not tow a trailer. off when the clutch pedal is pressed. accordance with ISO 1043, ISO 11469 and Between 1000 and 1500 kilometres (600 to ISO 1629. , increase power until 1000 miles) gradually reaching the maximum speed and high en- Choice of materials Run-in and economical driving gine speeds. ●Use of recycled materials. Running-in ●Use of compatible plastics in the same part Running in new tyres and brake pads if its components are not easily separated. ●Replacement of wheel rims and new tyres Please observe the instructions for running-in ●Use of recycled materials and/or materials ››› page 231 new components. originating from renewable sources. ●Notes on the brakes ››› page 141 ●Reduction of volatile components, includ- ing odour, in plastic materials. 148

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders