VW Beetle owners manual page 15

text version of content this owner's manual page from owners manual to the vehicle VW Beetle, year of production 2011:

¤Please first read and note the introductory information and heed the WARNINGS Instrument explanations ⇒ fig. 12: (1) Engine oil temperature indicator The engine has reached operating temperature when the needle moves into the center of the gauge under normal driving conditions. The needle may move farther to the right on the gauge with a heavier engine load at high outside temperatures. This is not a cause for concern as long as the indicator light E or does not light up or flash in the instrument cluster, Warning and indicator lights, Warning and indicator lights. (2) Stopwatch – Analog stopwatch that measures up to 60 seconds. – Digital stopwatch with hour, minute and second display (one tenth of a second intervals are shown up to 59 minutes and 59 seconds when the ignition is switched on). – Digital display with stop function selected. – Digital clock display with hours and minutes. If the timing function is not active, the digital clock will display after the ignition is switched on. (3) Boost pressure indicator The boost pressure indicator shows the pressure in the boost pressure duct between the su- percharger or turbocharger and the engine. The farther right that the indicator points on the gauge, the higher the pressure in the boost pressure duct and the greater the output from the engine. The word “Turbo” on the gauge indicates the system is charged. (4) Start / Stop / Reset button – Stopwatch mode (STOP-WATCH): press the button E3%4 once to start timing and press a se- cond time to stop. Press the button E3%4 again to resume timing. – Speed-dependent stopwatch mode (TIME-SINCE-START): the stopwatch starts automati- cally with an audible chime when you begin driving. Press once to stop the watch. – Press and hold longer than 2 seconds: the stopwatch resets. – When the digital clock (CLOCK) is displayed, you can switch between a 12-hour and 24-hour display by pressing the E3%4 button. (5) Button for stopwatch mode or digital clock You can switch between stopwatch modes and the digital clock display using the set bu. tton After selecting the stopwatch in the display, the mode displays briefly, followed by the last time that a time was recorded. – Stopwatch mode (STOP-WATCH). – Speed-dependent stopwatch mode (TIME-SINCE-START). The stopwatch starts automati- cally with an audible chime when you begin driving. An LED in the stopwatch comes on to indicate that this mode is active ⇒ . – Digital clock display (CLOCK). If the ignition is switched off while the timing function is active, the display will remain active for about 2 hours. If the timing function was not active when the ignition was switched off, the digital clock dis- play will turn off after about 30 seconds. The display will remain on for about 2 hours if you press the E3%4 or button within about 30 seconds after switching the ignition off. WARNING Rapid acceleration can cause skidding and loss of traction, especially on slippery roads, resulting in a loss of vehicle control, collisions, and serious personal injury. x Only use the stopwatch feature or fast accelraetion if visibility, weather, road, and traffic conditions permit and other drivers will not be endangered by your driving and the vehicle's acceleration.

owners manual VW Beetle

owners manual VW Beetle - year of production: 2011 - VW Beetle owners manual EN