owners manual Subaru Forester

all ratings: 0 average rating: 5

Instruments and controls 3-33 button, the compass display is toggled onother similar items. Periodically wipe thedisplayed. or off. When the compass is on, ansensors clean using a piece of dry soft4. Releasing the button for 3 seconds will illuminated compass reading will appearcotton cloth or an applicator.exit the zone setting mode. in the upper right corner of the mirror.! Compasszoneadjustment Even with the mirror in anti-glare mode, ! Compasscalibration the mirror surface turns bright if the 1. For optimum calibration, switch off all transmission is shifted into reverse. This nonessential electrical accessories (rear is to ensure good rearward visibility during window defogger, heater/air conditioning reversing. system, spotlight, etc.) and ensure all doors are shut. ! Photosensors 2. Drive to an open, level area away from large metallic objects or structures and make certain the ignition switch is in the “ON” position. 3. Pressandholdtherightbuttonfor6-7 seconds then release, and the compass will enter the calibration mode. “CAL” and Compass calibration zonesdirection will be displayed. 1. The zone setting is factory preset to4. Drive slowly in a circle until “CAL” Zone8. Refer to the “Compass calibrationdisappears from the display (approxi- zones”mapshownabovetoverifythatthemately two to three circles). The compass compass zone setting is correct for youris now calibrated. geographical location. 5. Further calibration may be necessary Themirror has a photosensor attached on2. Press and hold the right button for 3should outside influences cause the mirror both the front and back sides. If the glareseconds then release, and the wordto read inaccurately. You will know that from the headlights of vehicles behind you“ZONE” will briefly appear and then thethis has occurred if your compass begins strikes the mirror, these sensors detect itzone number will be displayed.to read in only limited directions. Should and make the reflection surface of the3. Press the right-hand button repeatedlyyou encounter this situation, return to step mirror dimmer to help prevent you fromto cycle the display through all possibleone of the above procedure and recali- being blinded. For this reason, use carezone settings. Stop cycling when the brate the mirror. not to cover the sensors with stickers, orcorrect zone setting for your location is – CONTINUED –

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders