owners manual Jeep Patriot

all ratings: 0 average rating: 5

UNDERSTANDINGTHEFEATURESOFYOURVEHICLE 141 has successfully accepted the frequency signal. The1. Turn the ignition switch to the ON/RUN position. indicator light will flash slowly and then rapidly when2. Press and hold the desired HomeLink button until fully trained. theindicatorlightbeginstoflashafter20seconds.Donot If you unplugged the device for training, plug it back inrelease the button. at this time. 3. Without releasing the button, proceed with Program- 3 Then proceed with Step 4 under “Programmingming Homelink Step 2 and follow all remaining steps. HomeLink” earlier in this section.Security Using HomeLink It is advised to erase all channels before you sell or turn To operate, simply press and release the programmedin your vehicle. HomeLink button. Activation will now occur for theTo do this, press and hold the two outside buttons for trained device (i.e., garage door opener, gate operator,20 seconds until the red indicator flashes. Note that all Security system, entry door lock, home/office lighting,channels will be erased. Individual channels cannot be etc. The hand-held transmitter of the device may also beerased. used at any time. ReprogrammingASingle HomeLink ButtonThe HomeLink Universal Transceiver is disabled when To re-program a channel that has been previouslythe Vehicle Security Alarm is active. trained, follow these steps:

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders