owners manual Land Rover Range Rover

all ratings: 0 average rating: 5

L Land Rover Homelink® Training a garage door opener equipped with e) Your garage door opener should now ® rolling codes recognise your HomeLink Transmitter. If To train your rolling code garage door opener to not, repeat the procedure but in step d), operate from your HomeLink® Transmitter, press and release the transmitter button follow these steps: three times. You may use either your ® 1.Program your hand-held transmitter to the HomeLink Transmitter or your original ® hand-held transmitter to open your garage HomeLink Transmitter by following the door. procedures outlined previously (if you have already completed this programming, If after following these suggestions you still ® proceed to the next instruction).have difficulties programming your HomeLink 2.Train your garage door opener receiver to Transmitter, call toll-free for customer ® assistance: 1-800-355-3515 or consult recognise your HomeLink Transmitter: www.homelink.com. (your garage door opener receiver will ® learn to recognise the HomeLink Erasing channels Transmitter by following the same process To erase all three programmed channels, hold used to train the hand-held transmitter).down the two outside buttons until the red light a) Remove the cover panel from your begins to flash, then release both buttons. garage door opener receiver (the receiver Individual channels cannot be erased, but can should be located by the garage door be reprogrammed using the procedures for motor). programming the HomeLink® Transmitter b) Locate the training button on the garage (steps 3 through 6). door opener receiver. The exact location and colour of the button may vary by garage door opener brand. If you have difficulty locating the training button, reference your garage door opener manual, call 1-800-355-3515 or consult www.homelink.com. c) Press the training button on the garage door opener receiver for 1-2 seconds, then perform the next step within 30 seconds. ® d) Return to the HomeLink Transmitter in the vehicle and depress the programmed button twice. Depress the button to ® confirm that the HomeLink Transmitter has been trained to the receiver. 142

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders