owners manual Land Rover Range Rover

all ratings: 0 average rating: 5

R Land Rover Homelink® Programming If after repeated attempts you do not ® 1. Turn the starter switch to the second successfully program the HomeLink position. Transmitter to learn the signal of the hand-held 2. If you have previously programmed your transmitter, call toll-free for customer ® assistance: 1-800-355-3515 or consult HomeLink Transmitter, proceed to step 3. www.homelink.com. Otherwise, hold down the two outside ® ® buttons on the HomeLink Transmitter Operating the Land Rover HomeLink until the red light (1) begins to flash Transmitter (approximately 20 seconds). Release both ® Once it is programmed, the HomeLink buttons. Transmitter can be used in place of your ® hand-held transmitter(s). To operate, simply This initializes the HomeLink Transmitter ® and erases previous settings from all three press the appropriate button on the HomeLink channels. Transmitter. The red light (1) comes on while DO NOT perform this step when the signal is being transmitted. programming additional hand-held Note: If your hand-held transmitter appears to ® transmitters. program the HomeLink Transmitter, but does 3. Decide which one of the three channels you not open your garage door and, if your garage want to program. door was manufactured after 1995, your garage 4. Hold the signal-emitting end of your door opener may have a code protected or hand-held transmitter 5 - 14 cm (1 - 3 in.) rolling code feature. ® A rolling code type of system will change the away from the HomeLink Transmitter code of your garage door opener every time you buttons so that you can still see the red open or close your garage door. status indicator light (1). 5. With one hand, push the hand-held To determine if you have one of these systems, transmitter button, and with the other, the depress the button on your HomeLink® desired button on the HomeLink® Transmitter that you programmed. If the red ® Transmitter. Continue to press both light on the HomeLink Transmitter flashes buttons through step 6. rapidly for 1-2 seconds, then lights 6. Hold down both buttons until you see the continuously, your garage door opener has a red light on the Land Rover HomeLink® rolling code system. Transmitter flash, first slowly and then rapidly (this could take up to a minute). It indicates that you have successfully ® programmed the HomeLink Transmitter to learn the new frequency signal. Release both buttons once the rapid flashing begins. 7. Turn the starter switch to the off position. 141

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders