owners manual Seat Toledo

all ratings: 0 average rating: 5

Checking and refilling levels climbing on mountain passes, the oil levelChanging engine oil The coolant concentration must not be re-s should preferably be kept within area A , but duced by adding water, even in warmer sea- ation no higher. Engine oil must be changed with the frequen-sons or in warm countries. The concentration ific cy indicated in the Maintenance Programmeof the anti-freeze additive in the coolant A warning lamp will appear on the instrument pec or according to the service interval indicatormust be at least 40 %. s panel ››› page 34, Engine oil  if the oil lev- al ››› page 45. el is too low. In this case, check the oil level If greater anti-freeze protection is required in hnic as soon as possible. Top up with the required very cold climates, the proportion of the anti-ec T CAUTION amount of oil. freeze additive can be increased, but only up Do not mix engine oil with additives. Risk of to 60% (anti-freeze protection down to ap- damage to the engine! Damage caused by CAUTION proximately -40 °C (-40 °F)). Exceeding this these products is not covered by the warran- proportion reduces anti-freeze protection and ● A e The oil level must never exceed area ty. ic the cooling effect. ››› Fig. 111. Risk of damage to the exhaust system! Adv Coolant fluid with protection down to -35 °C Note ● If the engine oil cannot be topped up under (-31 °F) is added at the factory in vehicles the given conditions,  do not drive on! StopWash your skin thoroughly if it comes into destined for countries with a cold climate. In the engine and seek the professional assis-contact with engine oil. these countries, the concentration of coolant tance of an Official Service, as this could should always be kept above 50%. cause serious damage to the engine. The type of anti-freeze to be used for topping up is indicated on the coolant tank cover Coolant ation ››› Fig. 112. Topping up engine oil Oper General notes CAUTION – Check the engine oil level ››› page 136, The cooling system is factory-filled with an● Anti-freeze that does not correspond to the Checking the engine oil level. anti-freeze product. correct specification may particularly affect – Unscrew the cap from the filler opening. corrosion protection considerably. Coolant consists of a mixture of water and – Put in the specified grade of oil 0.5 litres at ● Faults caused by corrosion may lead to 40% anti-freeze additive. This mixture gives a time ››› page 135. coolant leaks. Risk of serious engine faults!ety the required anti-freeze protection at temper- Saf atures down to -25 °C (-13 °F) and protects – Check the oil level ››› page 136. the cooling and heating system against cor- – Replace the oil filler cap carefully and push rosion. It also prevents scaling and raises the the dipstick all the way in. boiling point of the coolant considerably. 137

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders