owners manual Nissan Titan

all ratings: 0 average rating: 5

NOTE: 2. When the indicator light begins to flash ● position the hand-held transmitter1-3 Whenprogrammingagaragedooropener,inches (26 - 76 mm) away from theslowly (after 20 seconds), position the etc., it is advised to unplug the device dur-HomeLink surface. Hold the transmitter inhand-held transmitter1-3inches (26 - 76 ing the “cycling” process to prevent pos-that position for up to 15 seconds. Ifmm)awayfromtheHomeLinksurface. sible damage to the garage door openerHomeLink is not programmed within that3. Press and hold the hand-held transmitter components. time, try holding the transmitter in anotherbutton. position – keeping the indicator light in view OPERATINGTHEHOMELINK at all times. 4. TheHomeLinkindicatorlightwill flash, first UNIVERSALTRANSCEIVER If you continue to have programming difficulties,slowly and then rapidly. When the indicator please contact the NISSAN Consumer Affairslight begins to flash rapidly, release both TheHomeLinkUniversalTransceiver(oncepro-Department. The phone numbers are located inbuttons. grammed) may now be used to activate the ga-the Foreword of this manual.TheHomeLinkUniversalTransceiverbuttonhas rage door, etc. To operate, simply press the ap- propriate programmed HomeLink UniversalCLEARINGTHEPROGRAMMEDnow been reprogrammed. The new device can Transceiver button. The amber indicator light willINFORMATIONbe activated by pushing the HomeLink button illuminate while the signal is being transmitted. that was just programmed. This procedure will PROGRAMMINGTROUBLE- Individual buttons cannot be cleared. However,not affect any other programmed HomeLink DIAGNOSIS to clear all programming, press and hold the twobuttons. outside buttons and release when the indicatorIF YOUR VEHICLE IS STOLEN If the HomeLinkdoesnotquicklylearnthehand-light begins to flash (approximately 20 seconds). held transmitter information: REPROGRAMMINGASINGLE If your vehicle is stolen, you should change the ● replace the hand-held transmitter batteries codes of any non-rolling code device that has with new batteries. HOMELINKBUTTON been programmed into HomeLink. Consult the ToreprogramaHomeLinkUniversalTransceiverOwner’sManualofeachdeviceorcallthemanu- ● position the hand-held transmitter with itsbutton, complete the following.facturer or dealer of those devices for additional batteryareafacingawayfromthe information. HomeLink surface. 1. Press and hold the desired HomeLink but-When your vehicle is recovered, you will ● press and hold both the HomeLink andton. Do not release the button until step 4need to reprogram the HomeLink Univer- hand-held transmitter buttons without inter-has been completed.sal Transceiver with your new transmitter ruption. information. 2-58 Instruments and controls

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders