owners manual Seat Ateca

all ratings: 0 average rating: 5

Operation Convenience turn signals ly in the following situations ››› in Daytime Note nning lights on page 131: ru or the convenience turn signals, move the F ● If the convenience turn signals are operat- lever as far as possible upwards or down- ing (three flashes) and the other convenience Automatic switchingAutomatic switching wards and release the lever. The turn signal turn signals are switched on, the active part on off will flash three times. stops flashing and only flashes once in the new part selected. The photo sensor detectsWhen adequate lighting is The convenience turn signals are activated ● The turn signal only works when the igni-darkness, for example,detected. and deactivated in the Easy Connect system when driving through a tion is switched on. The hazard warning  up via the key and the Set function button tunnel. lights also work when the ignition is switch- ››› page 108. ed off. The rain sensor detectsWhen the windscreen wip- In vehicles that do not have the correspond- ● If a trailer turn signal malfunctions, therain and activates theers have been inactive for ing menu, this function can be deactivated in control lamp will stop flashing (trailer turnwindscreen wipers.a few minutes. a specialised workshop. signals) and the vehicle turn signal will flash at double speed. WARNING WARNING ● The main beam headlights can only be If the road is not well lit and other road users switched on if the dipped beam headlights Improper or lack of use of the turn signals, or cannot see the vehicle well enough or at all, are already on. forgetting to deactivate them can confuse accidents may occur. other road users. This could result in a seri-● In cold or damp weather conditions, the ● The automatic dipped beam control () ous accident. headlights, tail lights and turn signals may only switches on the dipped beam when ● mist up inside temporarily. This is normal and Always give warning when you are going to there are no changes in brightness, and not, in no way effects the useful life of the vehicle change lane, overtake or when turning, acti- for example when it is foggy. lighting system. vating the turn signal in good time. ● As soon as you have finished changing lane, overtaking or turning, switch the turn Main beam assist* signal off. Automatic dipped beam control * Main beam assist (Light Assist) WARNING The automatic dipped beam control is merely The main beam assist acts within the limits intended as an aid and is not able to recog- Incorrect use of the headlights may cause ac- of the system and depending on environmen- nise all driving situations. cidents and serious injury, as the main beam tal and traffic conditions. Once switched on, may distract or dazzle other drivers. When the light switch is in position , thethe system is activated as of a speed of vehicle lights and the instrument panel andabout 60 km/h (37 mph) and is deactivated switch lighting switch on and off automatical- ››› below about 30 km/h (18 mph) . 132

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders