Mitsubishi Lancer Sportback VIII 8 owners manual page 134

text version of content this owner's manual page from owners manual to the vehicle Mitsubishi Lancer Sportback, year of production 2007 - 2016:

BK0151000US.book 41 ページ㧞㧜㧝㧞年㧟月㧞㧥日　木曜日　午後６時㧤分 Features and controls When the engine is hard to start Startability of continuously variable transmission (CVT) After several attempts, you may experience that the engine stillvehicles or Twin Clutch SST vehicles at extremely cold does not start. ambient temperature 1. Make sure that all electric devices, such as lights, air con-When the ambient temperature is°F (-20 -4 ° C) or lower on vehicles equipped with CVT or -22 °F (-30 °C) or lower on ditioning blower and rear window defogger, are turned off. vehicles equipped with Twin Clutch SST or it may not be pos- 2. While depressing the brake pedal on vehicles equipped sible to start from a standstill even with the selector lever (CVT) or the gearshift lever (Twin Clutch SST) in the “D” with continuously variable transmission (CVT) or the (DRIVE) position. clutch pedal on the vehicles equipped with manual tran- This phenomenon occurs because the transaxle has not warmed saxle, press the accelerator pedal halfway and hold it up sufficiently; it does not indicate a problem. If this occurs, there, then crank the engine. Release the accelerator pedal, immediately after the engine starts. place the selector lever (CVT) or the gearshift lever (Twin Clutch SST) in the “P” (PARK) position and let the engine idle 3. If the engine still will not start, the engine could be 3 for at least 10 minutes. flooded with too much gasoline. While depressing the brake pedal on vehicles equipped with CVT or the clutchThe transaxle will warm up, and you will be able to drive nor- mally. pedal on the vehicles equipped with manual transaxle, Do not leave the vehicle during warm-up operation. push the accelerator pedal all the way down and hold it there, then crank the engine for 5 to 6 seconds. Return the ignition switch to the “LOCK” position and release the accelerator pedal. Wait a few seconds, and then crank the engine again for 5 to 6 seconds while depressing the brake pedal or the clutch pedal, but do not push the accelerator pedal. Release the ignition key if the engine starts. If the engine fails to start, repeat these procedures. If the engine still will not start, contact your local Mitsubishi Motors dealer or a repair facility of your choice for assistance. 3-41

owners manual Mitsubishi Lancer Sportback

owners manual Mitsubishi Lancer Sportback - year of production: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016 - Mitsubishi Lancer Sportback VIII 8 owners manual EN