Infiniti G V37 Coupe owners manual page 133

text version of content this owner's manual page from owners manual to the vehicle Infiniti G37, year of production 2008 - 2013:

PROGRAMMING HOMELINKT FORPROGRAMMING TROUBLE-DIAGNOSISCLEARING THE PROGRAMMED CANADIAN CUSTOMERS If HomeLinkT does not quickly learn the hand-INFORMATION Prior to 1992, D.O.C. regulations required hand-held transmitter information:Individual buttons cannot be cleared, however held transmitters to stop transmitting after 2● replace the hand-held transmitter batteriesto clear all programming, push and hold the two seconds. To program your hand-held transmit-with new batteries.outside buttons and release when the indicator ter to HomeLinkT, continue to push and hold light begins to flash (in approximately 20 sec- the HomeLinkT button (note steps 2 through 4● position the hand-held transmitter with itsonds). under “Programming HomeLinkT”) while youbatteryareafacingawayfromtheREPROGRAMMING A SINGLE push and re-push (“cycle”) your hand-heldHomeLinkT surface. transmitter every 2 seconds until the indicator● push and hold both the HomeLinkT andHOMELINKT BUTTON lightflashes rapidly (indicating successfulhand-held transmitter buttons without inter-To reprogram a HomeLinkT Universal Trans- programming). ruption. ceiver button, complete the following. NOTE: ● position the hand-held transmitter 2 to 5 in1. Push and hold the desired HomeLinkT If programming a garage door opener, etc., it is(50 to 127 mm) away from the HomeLinkTbutton. Do not release the button until advised to unplug the device during the “cy-surface. Hold the transmitter in that positionstep 4 has been completed. cling” process to prevent possible damage tofor up to 15 seconds. If HomeLinkT is not2. When the indicator light begins to flash thegaragedooropenercomponents.programmed within that time, try holdingslowly (after 20 seconds), position the the transmitter in another position - keepinghand-held transmitter 2 to 5 in (50 to 127 OPERATING THE HOMELINKT the indicator light in view at all times.mm) away from the HomeLinkT surface. UNIVERSAL TRANSCEIVER If you continue to have programming difficul-3. Push and hold the hand-held transmitter HomeLinkT Universal Transceiver (once pro-ties, please contact the INFINITI Consumer Af-button. grammed) may now be used to activate thefairs Department. The phone numbers are lo-4. The HomeLinkT indicator light will flash, garage door, etc. To operate, simply push thecated in the Foreword of this Owner’s Manual.first slowly and then rapidly. When the appropriate programmed HomeLinkT Universal indicator light begins to flash rapidly, Transceiver button. The red indicator light will release both buttons. illuminate while the signal is being transmitted. Instrumentsandcontrols2-59 w— — 07/14/07—pattieX

owners manual Infiniti G37

owners manual Infiniti G37 - year of production: 2008, 2009, 2010, 2011, 2012, 2013 - Infiniti G V37 Coupe owners manual EN