owners manual Seat Exeo

all ratings: 0 average rating: 5

exeo_EN.book Seite 130 Montag, 30. August 2010 4:45 16 130 Lights and visibility Rain sensor • Make sure you switch off the windscreen wiper system (lever in position The rain sensor* will only function in the intermittent wipe position. The inter-0) before you use an automatic car wash. This will avoid inadvertent trig- mittent wipe function is enabled automatically when it starts to rain.gering of the wipers and possible damage to the wiper system. If the windscreen wiper lever was in the intermittent wipe position when the ignition was off, the rain sensor will not activate until you reach a speed of 6 Note km/h. • Check that the washer fluid reservoir is full before starting a long journey. A Fill the reservoir ⇒page 231. Use switch A to set the sensitivity of the rain sensor*. • Worn or dirty wiper blades can cause smearing on the glass which can If you have selected a high sensitivity level for the rain sensor the windscreen also impair the effectiveness of the rain sensor*. Check the condition of wind- wipers will react sooner to any moisture on the windscreen. screen wiper blades at regular intervals. The wiper intervals in the intermittent wipe setting are also varied automati- cally according to the road speed (in addition to the sensitivity setting). Headlight washer system WARNING • For correct visibility and safe driving, the wiper must be in perfect condition ⇒page213. Failure to do so could result in an accident. • The rain sensor* is only intended to assist the driver. The driver is still obliged to manually operate the windscreen wipers as required depending on visibility. • Do not use water-repellent coatings on the windscreen. In bad visibility conditions such as light rain, low sun or when driving at night, these coat- ings can cause increased dazzle, which is a serious safety hazard. Such coatings can also cause the wiper blades to make noise. Caution Fig. 102 Headlight with • In the event of frost, check that the wiper blade has not frozen before acti- extended washer jet vating the windscreen wipers. Should the windscreen wiper system be enabled when the blade is frozen, this could damage it or even the wind-With the lights switched on, operate the automatic wash and wipe screen wiper system motor. 5 ⇒page129, fig.101 A, and keep the lever pulled towards you for at least 1 second.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders