owners manual Jeep Commander

all ratings: 0 average rating: 5

132 UNDERSTANDINGTHEFEATURESOFYOURVEHICLE Programming HomeLink 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) Before You Begin from the HomeLink buttons while keeping the EVIC If you have not trained any of the HomeLink buttons,display in view. erase all channels before you begin training.For optimal training, point the battery end of the hand- Todothis, press and hold the two outside buttons for upheld transmitter away from the HomeLink. to 20 seconds. The EVIC will display “CLEARING 3. Simultaneously, press and hold both the chosen CHANNELS.” Release the buttons when the EVIC mes-HomeLinkbuttonandthehand-heldtransmitterbutton sage states “CHANNELS CLEARED.” until the EVIC display changes from “CHANNEL # It is recommended that a new battery be placed in theTRAINING” to “CHANNEL# TRAINED.” hand-held transmitter of the device being programmedThen release both the HomeLink and hand-held trans- to HomeLink for more efficient training and accuratemitter buttons. transmission of the radio-frequency signal.If the EVIC display states “DID NOT TRAIN” repeat Your vehicle should be parked outside of the garageStep 3. If the signal is too weak, replace the battery in the while training. original hand-held transmitter. 1. Turn the ignition switch to the ON/RUN position.It may take up to 30 seconds, or longer in rare cases. The garage door may open and close while you train.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders