Hummer H2 owners manual page 127

text version of content this owner's manual page from owners manual to the vehicle Hummer H2, year of production 2002 - 2010:

Keep the original hand-held transmitter for use in other3. Simultaneously press and hold both the desired vehicles as well as for future Universal Home RemoteUniversal Home Remote button and the hand-held programming. It is also recommended that upon the saletransmitter button. Do not release the buttons of the vehicle, the programmed Universal Homeuntil Step 4 has been completed. Remote buttons should be erased for security purposes.Some entry gates and garage door openers may See “Erasing Universal Home Remote Buttons” laterrequire you to substitute Step 3 with the procedure in this section or, for assistance, see Customernoted in “Gate Operator and Canadian Assistance Offices on page 7-4.Programming” later in this section. Be sure that people and objects are clear of the garage4. The indicator light will ﬂash slowly at ﬁrst and then door or gate operator you are programming. Whenrapidly after Universal Home Remote successfully programming a garage door, it is advised to park outsidereceives the frequency signal from the hand-held of the garage. transmitter. Release both buttons. It is recommended that a new battery be installed in5. Press and hold the newly-trained Universal Home your hand-held transmitter for quicker and moreRemote button and observe the indicator light. accurate transmission of the radio-frequency signal. Programming Universal Home RemoteIf the indicator light stays on constantly, Follow these steps to program up to three channels:programming is complete and your device should 1. Press and hold down the two outside Universalactivate when the Universal Home Remote button is HomeRemotebuttons,releasingonlywhenthepressed and released. Universal HomeRemoteindicatorlight begins toTo program the remaining two Universal Home ﬂash, after 20 seconds. Do not hold down theRemote buttons, begin with Step 2 under buttons for longer than 30 seconds and do not repeat“Programming Universal Home Remote.” Do not this step to program a second and/or third hand-heldrepeat Step 1 as this will erase all of the transmitter to the remaining two Universal Homeprogrammed channels. Remotebuttons. If the indicator light blinks rapidly for two seconds 2. Position the end of your hand-held transmitterand then turns to a constant light, continue with about 1 to 3 inches (3 to 8 cm) away from theSteps 6 through 8 following to complete the Universal Home Remote buttons while keeping theprogramming of a rolling-code equipped device, indicator light in view. most commonly, a garage door opener. 2-51

owners manual Hummer H2

owners manual Hummer H2 - year of production: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010 - Hummer H2 owners manual EN