owners manual Seat Toledo

all ratings: 0 average rating: 5

toledo ingles.book Seite 122 Mittwoch, 11. April 2007 1:25 13 122 Lights and visibility • When the “intermittent wipe function” is on, the intervals are directly WARNING proportional to the speed. This way, the higher the vehicle speed the shorter • Worn and dirty wiper blades obstruct visibility and reduce safety levels.the intervals. • In cold conditions, you should not use the wash / wipe system unless • The wiper will try to wipe away any obstacles that are on the windscreen. you have warmed the windscreen with the heating and ventilation system. The wiper will stop moving if the obstacle blocks its path. Remove the The washer fluid could otherwise freeze on the windscreen and obscure obstacle and switch the wiper back on again. your view of the road. • Before removing any objects that may be trapped in the side areas of the • Always note the corresponding warnings on ⇒page218, “Changing windscreen, always move the wiper arms to the service position (horizontal). windscreen wiper blades”. • The heat output of the heated jets is controlled automatically when the ignition is switched on, depending upon the outside temperature. Caution In icy conditions, always check that the wiper blades are not frozen to the glass before using the wipers for the first time. If you switch on the wipers when the wiper blades are frozen to the windscreen, you could damage both the wiper blades and the wiper motor. Note • The windscreen wipers will only work when the ignition is switched on. • In certain versions of vehicles with alarms, the windscreen wiper will only work when the ignition is on and the bonnet closed. • When in use, the wipers do not go as far as the rest position. When the lever is moved to position 0, they are totally hidden. • The next speed down will automatically be selected if speed ⇒page121, fig. 85 2 or 3 is selected when the vehicle stops. The set speed will be A A resumed when the vehicle starts again • The windscreen will be wiped again after approximately five seconds once the “automatic wipe/wash system” has been operated while the vehicle is in transit (drip function). If you activate the wipers less than three secionds after the drip function, a new wash sequence will begin without the last wipe. For the “drip” function to work again, you have to turn the ignition off and then on again.

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders