owners manual Hyundai Genesis Coupe

all ratings: 0 average rating: 5

Features of your vehicle Programming Flashing ✽✽ NOTICE To train most devices, follow these Some devices may require you to instructions: replace this Programming step 3 Flashing with procedures noted in the "Gate Operator/Canadian Programming" ® section. If the HomeLinkindicator light does not change to a rapidly blinking light after performing these ® steps, contact HomeLinkat www.homelink.com. OYF042251N 2. Position the end of your hand-held transmitter 1-3 inches (2-8 cm) ® OYF042252N away from the HomeLinkbutton you wish to program while keeping 1. For first-time programming, press the indicator light in view. and hold the two outside buttons ® 3. Simultaneously press and hold ( , ), HomeLinkChannel 1 ® both the HomeLinkand hand- and Channel 3, until the indicator held transmitter buttons until the light begins to flash (after 10 sec- onds). Release both buttons. Do HomeLink® indicator light changes from a slow to a rapid blinking light. not hold the buttons for longer than 20 seconds. Now you may release both the HomeLink® and hand-held trans- mitter buttons. 4 40

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders