owners manual Volvo XC60

all ratings: 0 average rating: 5

03 Your driving environment ® HomeLink Wireless Control System* 4. At the garage door opener receiverIf you live in Canada or you are having diffi- NOTE (motor-head unit) in the garage, locateculties programming a gate operator or Some devices may require you to replace the “learn” or “smart” button. This cangarage door opener by using the “Program- this Programming Step 2 with procedures usually be found where the hangingming” procedures, replace “Programming noted in the “Gate Operator / Canadian antenna wire is attached to the motor-HomeLink” step 2 with the following: Programming” section. If the HomeLink head unit. indicator light does not change to a rapidly • Continue to press and hold the HomeLink blinking light after performing these steps, 03 5. Firmly press and release the “learn” orbutton while you press and release - contact HomeLink at www.homelink.com “smart” button. (The name and color ofevery two seconds (“cycle”) your hand- or by phoning the hotline at held transmitter until the HomeLink indi- the button may vary by manufacturer.) 1–800–355–3515. cator light changes from a slow to a rap- There are 30 seconds to initiate step 6. idly blinking light. Now you may release 6. Return to the vehicle and firmly press, 3. Firmly press, hold for five seconds and both the HomeLink and hand-held trans- hold for two seconds and release the pro- release the programmed HomeLink but- mitter buttons. grammed HomeLink button. Repeat the ton up to two separate times to activate Proceed with “Programming” step 3 to com- “press/hold/release” sequence a second the door. If the door does not activate, plete. time, and, depending on the brand of the press and hold the just-trained HomeLink garage door opener (or other rolling code button and observe the indicator light. equipped device), repeat this sequence aUsing HomeLink • If the indicator light stays on con- third time to complete the programming To operate, simply press and hold the pro- stantly, programming is complete process. grammed HomeLink button until the trained and your device should activate when device begins to operate (this may take sev- HomeLink should now activate your rolling the HomeLink button is pressed and eral seconds). Activation will now occur for released. code equipped device. the trained device (i.e., garage door opener, • If the indicator light blinks rapidly for Gate Operator/Canadian Programming gate operator, security system, entry door two seconds and then turns to a Canadian radio-frequency laws require trans-lock, home/office lighting, etc.). For conven- constant light continue with “Pro- mitter signals to “time-out” (or quit) after sev-ience, the hand-held transmitter of the device gramming” steps 4-6 to complete the eral seconds of transmission – which may notmay also be used at any time. In the event programming of a rolling code equip- be long enough for HomeLink to pick up thethat there are still programming difficulties or ped device (most commonly a garage signal during programming. Similar to thisquestions, contact HomeLink at: door opener). Canadian law, some U.S. gate operators arewww.homelink.com or by phoning the hotline designed to “time-out” in the same manner.at 1–800–355–3515. * Option/accessory, for more information, see Introduction.121

All pages in one PDF file!

How to get the code?
It's very simple! Just pay through a secure PayPal payment.
It will take no longer than a few minutes.
You will receive the code immediately after payment.
The code will be displayed on the screen and will be sent to you by e-mail address.

---

:

How many PDF files you want to download:
1 PDF file $4,00 USD 3 PDF files $8,00 USD 5 PDF files $12,00 USD

- I agree to the terms of service

Site map |
Privacy |
DMCA |
Terms of service
contact e-mail: contact @ man4car.com
All marks are the property of their respective holders